£0.69 exc vat
£0.83 inc vat
In stock
£0.69 exc vat
£0.83 inc vat
In stockRecommended usage 6 x GHF713 to fit one mini.
The original type pk screws for the original 2 piece rad cowlings pre 1974.
6 required
LED side repeater lamp for all 1986 on cars. No resisitor required
Resistor for AFU3389LED and AFU3389WLED, this is needed to enable the lamps to function properly. Sold in pairs.
INDICATOR LAMP WITH WHITE LENS AND LED BULBS. sold singly,2 required per car
Kit includes 2 original rear lower lens in white with reflectors plus 2 upper lens in white for the modern day look. Included are the 4 bulbs required to make the kit legal.
The lens seals are available individually as XFH100460...
Domed shape indicator lamp for all minis with single filament bulb, this is the aftermarket type with a white plastic lens and for glass type there is only a side asnd indicator type lamp which is 2A9013 but a white glass lens is [link]3...
White lens kit 1988 on. If your front indicator lens is held on by screws then this is the kit for your car with the side wing repeater lens also and correct orange bulbs.
If your front lens is held on by the chrome retaining ring as per all...
The front turn signals have an easy to replace chrome ring and this is the original chrome type replacement. See 7H5182MS for stainless steel.Sold singly, 2 required per car
The front turn signals have an easy to replace chrome ring but this is in stainless steel. Designed for CHM13 lamps with the plastic lens, it will need filing out to fit the glass lens units.Sold singly, 2 required per car.
This front turn lamp assembly was used on all Mkl & Mkll Saloons, all Vans and Pick-Ups. It is also an easy installation on later cars seeking that proper sixties look. Includes amber glass lens, chrome surround and rubber boot. The clips to hold thi...
Many intermittent electrical gremlins can be traced to a damaged or corroded bulb holder. This dual element socket is for combined park lamp and turn signal. The rubber boot that is supposed to protect it from corrosion is sold separately as [link]50...
Domed shape indicator lamp for all minis with single filament bulb, this is the aftermarket type with a plastic orange lens but if you are looking for the original glass lens type see 2A9013. Fitted up to 1986 and the clips that fit the ...
Plastic bulb holder for the wing side mounted flasher on cars from 1986 on--
make sure you change the seal AFU3112 when you dismantle these to stop water corrosion. sold singly, 2 per car required.
chrome on brass original type hexagonal screw for the chrome rear lamp BHA4153
This is the white lens kit for cars that have side repeater lens on the wing and earlier indicator lens that were held in by the chrome ring. Pre MSSK28 type
for about 1 year from 85-86 during cross over period where front indicator lamp the...
INDICATOR LAMP WITH ORANGE LENS BUT LESS BULB. Sold singly, 2 per car
This is the side repeater lamp that first appeared on the Mini Special in 1989
and on some special edition minis and the ADO16 model Austin, Morris and MG 1100/1300. The later 1986 cars had the square lamp PRC9916A fitted.
The outer white lens is the same as used on the conversion of the orange type used on 1986-1996 cars but the body was different on twin point cars and used a safety plug. The white lens if broken is moulded in the body but can be cleaned out complete...
INDICATOR LAMP WITH WHITE LENS LESS BULB. sold singly,2 required per car
This is the original correct colour orange (amber) lens for the side repeater lamp on the wing fitted up to the twin point cars which had white.
A white lens AHU2592W is available and fitted to 1996 on cars but remember to fit a...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.