STEERING WHEEL 3 SPOKE 13"LEATHER DISH BLACK NLA
33SBLB

(¥27) £27.00 exc vat

(¥32) £32.40 inc vat

Out of stockOut of stock
Leather 13" steering wheel with black dished spokes.

(¥27) £27.00 exc vat

(¥32) £32.40 inc vat

Out of stockOut of stock

People also bought products

Required to fit Mountney wheels to your Mini. The Mkl adapter Black boss has a built-in horn-push. The Mkll (BOSS/V3) is for cars with the horn on the stalk.

Large steering wheel nut for all pre air bag models, and a shakeproof washer 53K3480 must be fitted for safety reasons.1 5/16" spanner size 1.3125" wide (33mm).

This Retro Classic Cooper look a like- or even the Mota-lita look, has a Billet centre boss and vinyl covering giving a great look and feel. Will not fit air bag twin point injection models (mpi). This is a 13" diameter wheel.

All steering wheels pre air bag (twinpoint injection cars 1997 on) should have this shakeproof washer fitted under the large securing nut (ACH6001) and should be replaced every time the wheel is removed.

Reproduction gear lever gaiter for all remote control type gearboxes with the short gear lever by the driver's seat. The metal retainer for this gaiter is 14A9942. These were fitted until the introduction of the rod change type [link]CZH...

"Remote" gearshift boots 22A608 are readily available in aftermarket quality. Unfortunately, this metal retaining band had been unavailable from normal sources so we at Mini Spares recently took it upon ourselves to have our own manufac...

The first thing I do when I get a new Mini is to add a steering column adjuster. This bracket lowers the wheel 1" to 3" for a sportier driving position.

Always make sure you release the tension on the steering rack by loosening the 4 nuts o...

The black vinyl covering that lays on your lower dash shelf. For cars after 1970 where the facia panel is not a full metal panel you must fit (link)DT3076(/link)

Reproductions of the original black knob with engraved white shift pattern, complete with anti-vibration rubber insert.

Plastic upper bush that should be replaced when you have play between the inner and outer steering column. Remember to change the bottom as well whether it be felt or plastic type.

Dash liner black painted cardboard without airvents and oval hole for deluxe speedo cluster.Not for single speedo only cluster.For Vinyl leathercloth type see ALE2927

Grey with mirror fitted aftermarket sun visor for Mk3 models 1970-77 and 1992-96 which were thinner than pre 1965 for safety crash requirements. Check out the special clips to hold these visors as they are sold seperately in car sets only as [link]SV...

A car set of 4 special plastic clips and screws to hold in the sunvisors from december 1965 on SV2016P, SV2016W and SV2017P, SV2017W. For use on visors from 1965 that have a hinge either end.

Also known as brake failure switch, MK4 From 1976.

Rectangular switch for the rear heated screen with pin connectors plus a spade type. 3.1cm tall, from 1976 on.

HAZARD WARNING SWITCH, PIN TYPE CONNECTORS. MK4 FROM 1976. 3.1cm tall.

The interior rear view mirror in the Mini is the most often used in the car, it is also very visible from the outside. The three screw that hold them in place are almost universal regarless of the year of the car. The MK2 mirror only differs in size ...

Do not forget to replace the top plastic bush GSV1095 when replacing this lower felt type bush. From 1985 Rover changed to a plastic bush NAM8563 on the bottom with a different outer steering column shroud.

Replacement headlight switch as fitted to all models from 1976 until 1997.