(¥3) £2.70 exc vat
(¥3) £3.24 inc vat
In stock
If your fuse box is fine, but you've lost the lid, this is the cover for 606253A You DON'T want your bonnet prop falling directly on the fuse!
(¥3) £2.70 exc vat
(¥3) £3.24 inc vat
In stockRecommended usage 1 x 505158A to fit one mini.
Replacement fuse. 35 amp was standard for the light circuit and the 'all other' circuit, too, on early cars with the two circuit fuse box.
If you don't remember where your spares are, or you've used them up, you may want to replenish you...
Inline fuse holder with approximately 7" of wire to replace the old original holders located under the scuttle panel which corrode over time.
This is the latest model fuse box as used on all Minis after 1976 and all MG Midget/Sprites with 1275cc. Simple and easy to replace or upgrade from the earlier version. This box has the added advantage of having 4 fuses in place of the earlier vers...
This later type oblong fuse box cover was fitted to the box that held 4 fuses as opposed to two and was fitted from 1976-1996.
Complete fuse box less fuses is RTC440A.
circuit breaker for safety as required in motorsport
The switch has to be accessible from inside and outside the car.The external trigger should be located on the windscren scuttle panel -preferably the drivers side . It should be clearly ma...
Fuse Box-Pre 1976
Early style twin fuse box as used on many cars and models. If your box is corroded, as most are, then the "Price of Darkness" is bound to strike you.
This is the 'later' early model with blade connectors and comes...
Replacement fuse. 35 amp was standard for the light circuit and the 'all other' circuit, too, on early cars with the two circuit fuse box.
If you don't remember where your spares are, or you've used them up, you may want to replenish you...
Both personal safety and many sanctioning organizations require the use of switch for easy and complete cutoff of power from your battery. Easy to install and even provides a fused ancillary connection.
The most common use of this "great id...
Battery cut-off switch. FIA approved
Most race sanctioning bodies require the use of this special (diode protection device) cut out allowing the switching off whilst the engine is running without damaging the electrics. The switch has to be ...
Black relay for the air con fitted mainly on export models 94-96 and some GB cars with carb before injection, 4 spade terminals and markings are Siemens V23134-B1052-C842 12v for 12 volt and R61-10
Economy battery cut-off switch.
Most race sanctioning bodies require the use of a kill switch for easy and complete cut-off of power from the battery. The switch has to be accessible from inside and outside the car; the external trigger...
Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.
Battery bar and fitting kit for all pre 1990 cars whcih had the shorter battery bolts.
Dip switch lead for right hand drives cars, these are not included with new looms.
Pop rivet for fixing the headlamp bowl to the wing. Great for MS14 metal bowl but be careful if using on plastic bowls
rear stop and tail lamp for early BMc cars with red plastic lens.
Also stocked is a white lens and single filament bulb equivalent for use as reverse light on kits cars and Mokes as CHM13REVERSE.
Lots of things have been written about performance plug ignition wires but regardless of what you believe we all know that good wires are a must. This special competiton wires set from the Lucas factory has 8mm wire and the highest performance, no br...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.