Silicone heater hose, 39" for cars with the original heater valve bolted on the cylinder head.

Pre 1976 cars can use 2 0f these lengths, commonly known as 1/2" bore heater hose. also see C-GRH1007 for the longer 42" hose on 1976...

Red Silicon bottom Hose- Unless you're heavily into the concours scene you'll love these hoses! These silicone hoses will withstand higher temps and pressures and will last virtually forever! And if you ever had to replace a lower hose you'll appreci...

Original 7/16" spring type hose clip as used on later cars (approx 1990 on) for some radiator hoses and fuel lines.

Unless your're heavily into the concours scene you'll love these hoses! These silcone hoses will withstand higher temps and pressures and will last virtually forever! Made to fit 1275cc cylinder head the length is made to cover 1275cc engines includi...

Radiator hose kit for all pre 1989 1275cc Minis except clubman which has a longer top hose. the kit has top and bottom radiator hoses and two lengths of heater hoses(1m and 1.2m long)…all in shiney red Silicone. These should last forever and not degr...

Water pump fitting kit for models without bypass facility, includes new bolts, washers and superseal gasket.

Long lasting silicon by pass hose between cylinder head and water pump.

These are easy to cut and slide on easier than the old conventional rubber type.

It has been made this length to fit 1275cc engine,which used the longest hose.<...

Made for small bore Mk2 minis except clubman these super flexible hoses are easier to fit than rubber and last so much longer. See C-GRH003 also for all 998 Clubman and original MK1 radiator with longer top hose which measures 7" long (c...

Water hose pipe clip for the GRH1140 top hose and twin point injection cars which had larger hoses fitted .This clip will wind down to fit most radiator hoses if required.

If you drive A-Series cars long enough you will eventually have to replace the water pump bypass hose. These are the best quality available to fit without removing the cylinder head but these fluted rubber hoses have a bad reputation so if possible ...

Hose clip for 5/8" heater hose and used to locate 3/4" diameter anti roll bar in our C-AJJ4008 kit.

Metal type expansion or rad cap with no pressure spring, commonly used on race prepared cars and all Austin -Morros 1100/1200 derivatives plus Aussie Mokes.