(¥23) £22.89 exc vat
(¥27) £27.47 inc vat
In stock
(¥23) £22.89 exc vat
(¥27) £27.47 inc vat
In stockRecommended usage 2 x XBC103410 to fit one mini.
This is the complete lamp including the self level motor with plastic backing bowl as fitted to late injection cars and German/Japan spec vehicles (will require wiring)
Pop rivet for fixing the headlamp bowl to the wing. Great for MS14 metal bowl but be careful if using on plastic bowls
Gasket/seal for all 1997 on mpi headlamp bowls (self levelling type).
A single plastic headlamp bowl only, to accept the levelling motor and rim for all twin point (1997 onwards) Minis plus some export SPI models.
For wipac quadoptics-replacement bulb holder for lamps also supplied in kit.
Even at normal highway speeds it is common to "outdrive" conventional headlamps. The halogen headlamps have very bright 55/60 watt bulbs. Their special lens gives g...
The best chrome type available with screw and washer.
A headlight trim ring is only the starting point of a good looking car, but you have to start somewhere. Sold singly 2 required per car. These are the original type chrome over solid bras...
TWin point and overseas cars were fitted with headlamps that self-level for when carrying loads. This is the motor in the headlights.
These are for Left had drive L/H/D. See S4698B for Right hand drive R/H/D.
Even at normal highway speeds it is common to "outdrive" conventional headlamps. These halogen headlamps have very bright 55/60 watt bulbs. Their special...
If your rusted old headlight bucket is getting to you, don't waste time trying to salvage it when new metal reproduction metal buckets are AVAILABLE.
With a headlamp rim fixing bracket 37H7421 attached
Whether you are ...
The headlamp bucket is isolated from the body with these rubber seals/gaskets.
Headlamp sundries kit.
Includes two adjuster screws, plastic nutserts, pullback spring. Two kits are required per car.
A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...
As fitted from Cooper SE on,it is also fitted to the MPI injection cars with self levelling units. This light unit has a plastic backing and not metal as per our S4700 type.This part is not in a complete lamp but just the glass unit.For ...
This is the complete lamp including the self level motor with plastic backing bowl as fitted to late injection cars and German/Japan spec vehicles (will require wiring)
L/H/D Headlight unit to accept separate main beam bulb and auxiliary bulb. Uses GLB410 bulb. Sold singly 2 required per car.
This plastic bowl kit includes the inner rim to hold your light unit and will obviously not rust like the old originals. You will need a headlamp outer rim so why not fit our own developed stainless steel variety which is cheaper than even chrome bud...
These stainless steel peaks fit under the headlamp rim to give that old 60s style again.
Single replacement unit for the right hand drive kit S4698B with left hand dip
lamp part only, does not include the rubber cover, bulb or side light part
This will replace the orange lens fitted on the wing of all cars from 1986 on, fitted with an orange LED. If you need a new loom for this lamp see AFU3358. Sold singly. Does not require a resistor.
INDICATOR LAMP WITH WHITE LENS AND LED BULBS. sold singly,2 required per car
Stainless steel screw kit for all mk2/3 lens to lamp body. Comes as a car set with six screws and six fibre washers.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.