($21.15) £21.15 exc vat
($25.38) £25.38 inc vat
In stock
($21.15) £21.15 exc vat
($25.38) £25.38 inc vat
In stockRecommended usage 2 x XBC104430 to fit one mini.
Headlamp bulb found in many of the post sealed beam unit cars. An upgrade is available as GLB472X.Sold individually
Gasket/seal for all 1997 on mpi headlamp bowls (self levelling type).
A single plastic headlamp bowl only, to accept the levelling motor and rim for all twin point (1997 onwards) Minis plus some export SPI models.
For wipac quadoptics-replacement bulb holder for lamps also supplied in kit.
Even at normal highway speeds it is common to "outdrive" conventional headlamps. The halogen headlamps have very bright 55/60 watt bulbs. Their special lens gives g...
The best chrome type available with screw and washer.
A headlight trim ring is only the starting point of a good looking car, but you have to start somewhere. Sold singly 2 required per car. These are the original type chrome over solid bras...
Single replacement light unit for the Left Hand drive kit S4699B with right hand dip.
lamp part only, does not include the rubber cover, bulb or side light part
These are R/H/Drive, see S4699B for L/H/D.
Even at normal highway speeds it is common to "outdrive" conventional headlamps. These halogen headlamps have very bright 55/60 watt bulbs. Their special lens gives good long range visi...
If your rusted old headlight bucket is getting to you, don't waste time trying to salvage it when new metal reproduction metal buckets are AVAILABLE.
With a headlamp rim fixing bracket 37H7421 attached
Whether you are ...
The headlamp bucket is isolated from the body with these rubber seals/gaskets.
Headlamp sundries kit.
Includes two adjuster screws, plastic nutserts, pullback spring. Two kits are required per car.
A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...
This is the complete lamp including the self level motor with plastic backing bowl as fitted to late injection cars and German/Japan spec vehicles (will require wiring)
This plastic bowl kit includes the inner rim to hold your light unit and will obviously not rust like the old originals. You will need a headlamp outer rim so why not fit our own developed stainless steel variety which is cheaper than even chrome bud...
These stainless steel peaks fit under the headlamp rim to give that old 60s style again.
Single replacement unit for the right hand drive kit S4698B with left hand dip
lamp part only, does not include the rubber cover, bulb or side light part
Stainless steel screw kit for all mk2/3 lens to lamp body. Comes as a car set with six screws and six fibre washers.
Foam gasket that goes between the indicator/side lamp unit and front panel for all clubman models
THE LENS FIXING SCREWS FOR THE REAR LENS ON MK4 1976 ON WITH REVERSE LENS ARE ALL THE SAME. SOLD INDIVIDUALLY. ALSO FITS TWIN POINT FRONT INDICATOR LAMP.
3 per lamp required or 6 per car set.
Interior lamp bayonet type bulb from late 1984-10 watt the same size fitting as GLB207 which is often used although only 5 watts.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.