Contents are either a 3.75”, 5” of 6” inlet manifold linkage kit which includes the following:
1 ACC5062 throttle cable trunnion
2 GFK1114 washer
2 GFK3212 nut
2 GFK3295 5mm nuts for M520 bolts
2 M520 bolt for throttle levers
2 HAR002 throttle lavers
2 HAR003 small rose joints for threaded rod
1 HAR004 throttle 5/16” rod
1 HAR005 threaded rod for HAR003
1 HAR001 5” long plate
2 RM5U spherical ended joints for 5/16” rod

Build the manifold up before fitting to the car,
The two spherical ended joints screw into the inlet manifold using the flat washers and nuts to lock them into place.
The 5/16” rod is a tight fit into the two joints and care must be taken when fitting.
The two linkage brackets fit either end of the 5/16” rod outside of the spherical joints using the 5mm nut and bolt to secure.
Fit the small rose joints either end of the threaded rod and fit to the throttle linkage on the side required for the Weber carb being used.
The 5” metal bar fits in a vertical position to the manifold, secured on the original manifold studs when fitting to the engine.
The small hole at the top will allow the inner of the throttle cable to pass through and a new linkage lever pin is supplied to fit the cable to the throttle lever.