LEVER FOR LINKAGE 001
HAR002

£2.05 exc vat

£2.46 inc vat

In stockIn stock

£2.05 exc vat

£2.46 inc vat

In stockIn stock

Recommended usage 2 x HAR002 to fit one mini.

Kit products

This fitting kit suits all later day 1.25" and 1.5" twin carb set ups where the balance rods between the carbs required are equal length (2.25"), some early carbs had the balance bar with a triangular plate that were a shorter length. The kit has the...

This is the kit supplied with our C-AHT772, C-AHT773 & C-AHT774 range of alloy inlet manifolds for the weber.

People also bought products

This is the original type of needle valve that governs the plastic fuel float in your SU carb.

An alternative better upgraded version is available as CA90.

Clip on the heater valve for heater cables on vehicles from 1990 where the in line remote heater valve was used. It has also been used as a clip for HIF carbs to hold the cable but the one from Rover is 13H3472.

Stainless steel twin HS4 heatshields kit. Comes with Link bar and springs.

Throttle return springs for all twin carb variants. Usually 3 fitted.

This is the right hand linkage lever taht sits on the rods between HS type twin carbs. Sold individually

Pair of heatshield brackets and cross bar

these are made similar to the original cooper HS2 design but ARE for HS4 (1.5")carbs and include the 3 correct springs that attach to the bridging bar for choke return linka...

Manifold to carb gasket for HS2 single and twin carbs, usually 3 per carb required.

Used in petrol fuel lines to take 1/4" petrol hoses it is used mainly on twin carb set ups for petrol being diverted to the 2 carbs.

Mini Spares own performance upgrsded paper gasket that sits either side of the carb to manifold spacer on HIF38/44 type 1.75" carbs.Sold singly, order quantity as required to suit your car.

Gasket for an HS4-carb and manifold .Sold seperately and order as required for your car(usually 3).

This is the left hand linkage lever that sits on the rods between HS type twin carbs.sold individually

The proper slot head screw for the SU dashpot and float lid 3/16 whitworth thread.

Accelerator bracket for twin carb models, mounts to inlet manifold.

The rod with the plate is called the butterfly rod and was fitted to all Cooper twin carb HS2 set ups.

This fitting kit suits all later day 1.25" and 1.5" twin carb set ups where the balance rods between the carbs required are equal length (2.25"), some early carbs had the balance bar with a triangular plate that were a shorter length. The kit has the...

Rod with chamfered ends about 57.2mm long(shorten to 54mm for twin HS4) which has AUE586 and AUE587 clamps on to fit between SU twin carbs for the linkage. Quantity of One is usually required per set up plus a 12A31...

Also denoted by its black plastic base. Twin HS4 carbs have 30 degree float bowl angles and therefore this jet is easier to fit as it is longer. L/H carb uses AUD9098A std single HS2 jet.



For...

this is the plain butterfly disc for the HS4 1.5" carb and if you have the air valve type butterfly disc see WZX1325