£0.42 exc vat
£0.50 inc vat
In stock
£0.42 exc vat
£0.50 inc vat
In stockRecommended usage 3 x 88G429B to fit one mini.
High quality klinger gasket that sits either side of the carb to manifold spacer on HIF44 type 1.75" carbs or HIF38. Now also sold as PKX100020EVA by Xpart
For a cheaper alternative see 88G429B sold singly.
Genuine head gasket set to suit A plus engines with the late head gasket which is considered one of the best. For all models with HIF44 and HIF38 except it has no elbow gasket for HIF38 carb to air cleaner.
See GUG701114HS for H...
same kit as C-STN18 but with the correct needle for the larger HIF6 carb 1.75"
which has a 100 thou jet tube--an alternative to the needle supplied is BDL if other slight modifications or exhaust changes heve been made
Performance Stage one kit for 1300cc models with HIF44 Carb with centre exit exhaust system RC40-12
Performance Stage one kit for 1300cc models with HIF44 Carb with side exit large bore exhaust system RC40-10
STAGE 1 KIT FOR MINI VAN, ESTATE AND PICKUP. Mini Spares bolt-on performance kit for 1275cc engines with HIF44. Gives 20% more power and 12% more torque.
Always get your car rolling roaad tested for best ignition/timing and emmissions after ...
Screw for holding the needle guide on HIF44, HIF38 carburettors. Also fits HS6.
This is the original type of needle valve that governs the plastic fuel float in your SU carb.
An alternative better upgraded version is available as CA90.
Twin carb HS2 (1.25")black heatshields with link bar and 3 new return springs.
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
Orange ...
Clip on the heater valve for heater cables on vehicles from 1990 where the in line remote heater valve was used. It has also been used as a clip for HIF carbs to hold the cable but the one from Rover is 13H3472.
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
Orang...
Stainless steel twin HS4 heatshields kit. Comes with Link bar and springs.
Throttle return springs for all twin carb variants. Usually 3 fitted.
This is the right hand linkage lever taht sits on the rods between HS type twin carbs. Sold individually
Air ducting tube from inlet manifold to air cleaner. These are 5.5" long which covers the longest but some such as the injection model is only 1.5" OR 2-2.5" long.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.