High quality klinger gasket that sits either side of the carb to manifold spacer on HIF44 type 1.75" carbs or HIF38. Now also sold as PKX100020EVA by Xpart

For a cheaper alternative see 88G429B sold singly.

Spacer suitable for HIF44/38 carbs, 9.5mm thick and supplied without gaskets.

picture shoen is only to illustrate use of gaskets GUG705561GM.

To convert a standard UK spec Single Point Injection car to HIF44 carb. This kit includes wiring looms,fuel tank,fuel pump, carb, air filter and inlet manifold.

Screw for holding the needle guide on HIF44, HIF38 carburettors. Also fits HS6.

Return spring kit for HS4 carburettor spindle.

Universal stud made for fitting the HS4/HIF carb to the manifold (except HS6 with alloy spacer on cast one piece manifold which requires CHS2515 (5.8mm longer)) and it also fits the cylinder head to take the thermostat housi...

Twin carb HS2 (1.25")black heatshields with link bar and 3 new return springs.

Clip on the heater valve for heater cables on vehicles from 1990 where the in line remote heater valve was used. It has also been used as a clip for HIF carbs to hold the cable but the one from Rover is 13H3472.

GASKET BETWEEN CARB AND AIR CLEANER ALLOY ELBOW

Throttle return springs for all twin carb variants. Usually 3 fitted.

Pair of heatshield brackets and cross bar

these are made similar to the original cooper HS2 design but ARE for HS4 (1.5")carbs and include the 3 correct springs that attach to the bridging bar for choke return linka...

Manifold to carb gasket for HS2 single and twin carbs, usually 3 per carb required.