£92.73 exc vat
£111.28 inc vat
Out of stock
3 synchro mainshaft is shorter than 4 sync
the 18mm nose late 4 sync mainshaft
is shorter than the 14mm nose 4 sync shaft
£92.73 exc vat
£111.28 inc vat
Out of stock
This little roller bearing goes inside the end of the 1st motion shaft on minis with 14mm mainshaft which it sits on.
This bearing was previously part number 88G409 and a true Rover replacement, but if you have earlier A type gears with the...
The 25.4mm wide original genuine bearing to take 19.05mm size idler gear shaft and sits in the gearbox case on early 3 synchro types and also in the early type clutch case. There is a cheaper version on the market but for gearbox safety sake we have ...
When in doubt replace it. You have heard this many times but you better believe it on this part. If you have not personally just replaced these layshaft bearing then do it now while you have the chance. These bearing will destroy the inside of a very...
Genuine RHP Outer support bearing for the first motion shaft. Comes with bearing and outer race. You MUST REPLACE the outer race when using the new bearing. An easy way to remove the old race is to clean the housing very well, remove the circlip, and...
Gearbox differential pinion locktab to secure it on the mainshaft for all manual gearboxes.
These needle rollers were fitted under 2nd and 3rd gears on the 3 synchro B type gears gearbox only. 26 per gear and used on MG midgets also.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.