£222.90 exc vat
£267.48 inc vat
In stock
£222.90 exc vat
£267.48 inc vat
In stockRecommended usage 1 x 3221 to fit one mini.
Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.
Dip switch lead for right hand drives cars, these are not included with new looms.
A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...
Large grommet to fit 1"approx holes in bulkhead for items that need to be able to flex and move such as capillary tubes and oil pipes. 7/32" hole size.
The small hole will expand and is also used as wiring loom through bulkhead and battery c...
Plastic holder for the later flasher unit GFU2218. Needs to be mounted to the bulkhead prior to fitting the flasher unit to the holder
Fits metal headlamp bowl to fix headlamp outer rim, sold singularly.
Almost any screw will hold the chrome headlamp bezel on, but only one is correct! These screws are stainless steel and will never corrode plus they have the little rubber washer on the backside so that the screw will not fall out when trying to fit ...
If your rusted old headlight bucket is getting to you, don't waste time trying to salvage it when new metal reproduction metal buckets are AVAILABLE.
With a headlamp rim fixing bracket 37H7421 attached
Whether you are ...
chrome on brass original type hexagonal screw for the chrome rear lamp BHA4153
This is known as a metalastic type bush as it is metal on the outside and inside with a layer of rubber between. Used on the rear rod change gearbox as a stabiliser bush for the rod change it is also used on our rear anti roll bar kits where appropri...
Thermal transmitter fitted in the cylinder head from 1970 on until its demise on the 1990 Coopers this part was the same as GTR143. One number was original fitment and the other supplied as the spare part by Unipart.
Fits 998 1275 and cooper...
This is the indicator orange coloured bulb you require when the lens is plain
or white coloured. The pins on these are opposite each other whereas the twin point lamps have offset pins GLB344 and appear at a 2 o'clock angle whe...
The mini switch with the little green flasher on the end, it was fitted to the MK1 only. The green lens is 47H5200.
These fit twin point only as they have a loom safety socket fitting.
OE chrome headlamp rim.
These chrome over ordinary steel headlamp rings are bagged or boxed & NOT including setscrew. Setscrew is RTC465. Using steel, they are however prone to rusting so Minispares have made a high quality chrome over brass...
This rubber boot covers the indicator/turn signal housing inside the fender. Fits the Mini and it's the same front & rear for the Bugeye sprite and various other British cars.
This plastic bowl kit includes the inner rim to hold your light unit and will obviously not rust like the old originals. You will need a headlamp outer rim so why not fit our own developed stainless steel variety which is cheaper than even chrome bud...
These stainless steel peaks fit under the headlamp rim to give that old 60s style again.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.