MK1 REAR LAMP GASKET SET FOR 1 LAMP
57H5399

£2.85 exc vat

£3.42 inc vat

In stockIn stock
Mk1 tail lamps each have a pair of heavy rubber foam gaskets. One between the lens and the chrome base, a similar one between the base and the body. Since they are exposed to the sun and easily visible, faded or rotted gaskets can ruin the look of the whole car! This kit includes one of each gasket, two kits required per car. If the special mounting screws are damaged or missing see screw kit 47H5360.

£2.85 exc vat

£3.42 inc vat

In stockIn stock

Recommended usage 2 x 57H5399 to fit one mini.
Lamps rear / Number Plate / & Interior - Qty 2

Recommended products

Set of three screws to hold the lens for the MK1 rear lamp.

People also bought products

Interior lamp with a black on/off switch and pointed torpedo ends.

Also fitted many of the 1959on range of Austin A55/60 Cambridge, MG Magnette etc.

Also there was an alternative lamp with black switch and square ends 13H192 which w...

Reverse lamp as used on some Mokes/kit cars etc, essentially the same as our indicator lamp CHM13WHITE but with a clear single filament bulb rather than orange and white plastic lens.

Pop rivet for fixing the headlamp bowl to the wing. Great for MS14 metal bowl but be careful if using on plastic bowls

rear stop and tail lamp for early BMc cars with red plastic lens.

Also stocked is a white lens and single filament bulb equivalent for use as reverse light on kits cars and Mokes as CHM13REVERSE.

Gasket/seal for all 1997 on mpi headlamp bowls (self levelling type).

Resistor for AFU3389LED and AFU3389WLED, this is needed to enable the lamps to function properly. Sold in pairs.

Screw for holding PRC1230A to the number plate light body, 1970 onwards.

Screw for chrome metal number plate lamp on mk3 19790 on - You will have to drill the lens out to take M4 screw.

This is the plug that fits on the back of the front indicator lamps (XBD100670) on mpi models.

INDICATOR LAMP WITH WHITE LENS AND LED BULBS. sold singly,2 required per car

INDICATOR LAMP WITH ORANGE LENS AND LED BULBS. Sold singly, 2 required per car

Stainless steel screw kit for all mk2/3 lens to lamp body. Comes as a car set with six screws and six fibre washers.

The half bowl for holding original sealed beams into the headlamp bowl om minis and many other headlamps of the 60s and 70s. Sold singly 2 required per car.

A single plastic headlamp bowl only, to accept the levelling motor and rim for all twin point (1997 onwards) Minis plus some export SPI models.

Foam gasket that goes between the indicator/side lamp unit and front panel for all clubman models

Interior lamp (dome lamp) lens. Fitted from 1959 to 1974 (mk 1 2 3).

Fits our 14A9148 and 13H4398 lamps

Genuine Mini Spares L/H lamp with white lenses. This type of lamp was fitted from 1976 on as standard equipment with a built in reverse lamp.

Supplied with gaskets and correct coloured bulbs this has the more fashionable/retro white upper ...

Genuine Mini Spares R/H genuine lamp with white lens. This type of lamp was fitted from 1976 on as standard equipment with a built in reverse lamp. Supplied with gaskets and correct coloured bulbs this has the more fashionable/retro white upper lens...

THE LENS FIXING SCREWS FOR THE REAR LENS ON MK4 1976 ON WITH REVERSE LENS ARE ALL THE SAME. SOLD INDIVIDUALLY. ALSO FITS TWIN POINT FRONT INDICATOR LAMP.

3 per lamp required or 6 per car set.

Interior lamp bayonet type bulb from late 1984-10 watt the same size fitting as GLB207 which is often used although only 5 watts.