Genuine Mini Spares manufactured bumper from our own tooling that fits perfectly as per original ROVER bumpers. Better than the last genuine bumpers produced for Rover which is why we laid down tooling - BEWARE - most others available in stainless ar...

Brackets, bolts and rubber seating to hold 4 overiders on with the seating seal.

If you have overiders with corner bars you need kit MSSK010.

Stainless steel stud for original production factory fitted sports pack arches.

These use FN105047 nuts.

New genuine arches now have an upgraded threaded brass insert and now use a stud ZUA000250.

Wheel arch fitting kit for MS127 Mini Miglia arches.

Original shape washer jet for Mk1/2 minis. Made to the same specification as the last type made for rover parts sales with a nut on a loose thread so it can be tightened easily by hand in the engine bay without any modifications. Should be used with ...

Minispares 2 piece plastic roof moulding kit specially shaped for the corners and drain holes as fitted from 1980on in black.

The 2 joining and finishing clips are DBE10006PMD which need to be ordered seperately. The last Rover...

The scrivet for holding the front of the rear wheel Sportspack arch and the rear of the front arch. Rover also used rivet RY612535 as an alternative.

In 1993 the moulding between the wheel arches was changed from black plastic to rubber and was still used on twin point rubber arches. This is the Minispares version which is a slightly more rounded profile.

Chrome on plastic, slightly fatter than the original black plastic mirror fitted from 1980 on. This is an ideal cheaper replacement mirror for JPC9849 L/H as fitted by Rover from 1980 on.

The best chrome type available with screw and washer.

A headlight trim ring is only the starting point of a good looking car, but you have to start somewhere. Sold singly 2 required per car. These are the original type chrome over solid bras...