BRACKET FOR LOWER DASH PAD L/H
ALA6653

£6.95 exc vat

£8.34 inc vat

In stockIn stock
Bracket, mk2 switch panel, LH. Locates swith panel to lower dash rail when ALA6621 is fitted. 1967-1987.

£6.95 exc vat

£8.34 inc vat

In stockIn stock

Recommended usage 1 x ALA6653 to fit one mini.

Recommended products

Bracket, mk2 switch panel, RH. Locates swith panel to lower dash rail when ALA6621 is fitted. 1967-2000.

People also bought products

Our lightweight underfelt kit is the perfect companion when fitting a new headlining. Made from lightweight felt and cut to size, this fits into the cavity of the roof before fitting your new headlining and provides increased sound insulation and pro...

The chrome moulding to fit the door bin on first 80 thousand MK1 minis with extra length tag with screw hole for location.

This is held on by screws but a single sided prong clips ADH3809 can be used in the centre - beware other...

Black with mirror, optional colour aftermarket sun visor for Mk3 models which were thinner than pre 1965 cars for safety requirements. Will fit cars from December 1965 on. Check out the special clips to hold these visors as they are sold seperately ...

Complete car set of roof lining rods, comprising of 1 Red, 2 White, 1 Black, 1 Blue and 1 Yellow

number 1 with red ends is EEB100060

number 2 and 3 is white ends are both EEB100070

number 4 with black ends is EEB100080
...

Black sun visor less mirror that requires clips both ends but never a standard fitment colour fits cars from Dec 1965. Available as a sought after alternative to the cream colour. The brackets are available as a car set only(4 clips) as SV20...

Ideal for solving the problem of fitting extra speaker's, this speaker board is simple to fit, and well finished speaker holes are oval 6"x9"

Full carpet boot liner kit, completely lines the inside of the boot area.



Not suitable for MPI minis.

The rubber type grip fitted on handbrakes-

will fit any single cable hand brake from 1976 on

Mk1/2 used 13H5541 thinner plastic type--to fit this to pre 1976 early cars you will need to put lots of sticky tape on the h...

Metal plate switch carrier for 5 square type switches.

The metal retainer that holds the rod change gear lever gaiter CZH4278 in place

MK1/2 style pattern door and rear quarter black vinyl trim kit for MK3 on

These are the 4 major parts that can give your car a fresh look- only fits wind up window type doors as fitted to MK3 range mid 1973 on , without ash tray facility in...

Fitted 1969-77 and 1992-96 originally and white from 1970-96 so see PAM5401BLACK and PAM5401AP. C posts trims changed with MPI or Heritage shells.

These headlinings are held in by different shape/length rods which a...

Uses ADU8081 screw and YXX3200PA cover. With a spring loasded winder knob this handle was fitted to later cars as a safety requirement. Fitment was from 1983 but fully introduced in 1984

Plastic interior door pull handle fitted to Mk3 cars until approx 1983.

The chrome boss at either end CZH763 are no longer available.



Rovers last offering was in fact a GLZ118 for 1100/1300 rang...

Metal chromed old type classic handle revived for use on MG variants and then a fashion item on minis. On later cars CMZ312 screw might be required which has a smaller diameter head and longer thread. Length 90mm.

2 outer rings and 2 inner knobs which have to be stuck on.

Favourite old ashtray for MK1/2 minis with the fluted top for the rear glovebox and facia. Fitted to minis with painted top dash rail from 1959-85.

See 24A1538 also for flat lid version as fitted when top dash rail is vinyl cove...

If you have twin original 5.5 gallon tanks this 26" wide boot board is the one for you.

Bezel for 24A2702 oval 3-gauge pod. This is the brightwork trim on the front of the plastic pod, it is held on with up to 14 whisker clips 14A9796. The clip to join the ends together for neatness is 24A472
<...