This new type suspension cone tool for removing or refitting the rubber suspension cone is METRIC thread only and improved by using a hex(allen)key to screw in and hold the centre spindle. There cannot be many cars left out there with the AF type th...

Replacement rubber cone produced from original factory tooling to the original specification, complying to the original Rover/BMC drawing and manufactured in the UK and easily identifiable by having the original patent number "763432" moulded in to t...

Genuine Mini Spares part improved from original for the L/H upper mounting point of your damper(shock absorber) and fit 14A6948 captive nut plates for upper bolt fixings . For lowered suspension use C-AJJ3359

Upgraded, lower EN8 damper pin. 3/8"unf. Sold singly

Especially useful for competion cars or street cars with lowered suspension.

Its quite a good idea to change these if they are corroded to give a better seating for your dampers.<...

Genuine Mini Spares part improved from original for the R/H upper mounting point of your damper(shock absorber) and fit 14A6948 captive nut plates for upper bolt fixings . For lowered suspension use C-AJJ3359

Genuine Mini Spares UK made complete joint with the following specifications,

correct dimensions and shape of pin and ball in EN24T, using correct spec grease,

genuine original shape cup using correct material (21A423MS...

Standard gas filled replacement front shock absorber from Bilstein.



Non hand adjustable front damper guide ratings

442001 KYB standard replacement

342001 KYB Gas filled 25% upgrade on sta...

Pair of front and rear gas self adjust dampers/shock absorbers at a special price

one piece forged lower rod end arms

unbelievably at this price they are not the welded type as sold by many of our competitors

Same as the C-AJJ3360 lower arm kit, but includes the spherical rod ends,spacers and dustcov...

Genuine Mini Spares product ideal for road use for maximum performance, where other examples available tail off as they get worked and heat up.

Hilos will be required to enable fitment as they are taller but FAM3968EVO are a str...

Angled grease nipple for the upper arm on the front suspension of all Minis

importantly lubricates the upper arm spindle which so often gets neglected so check yours out and make sure this nipple is working properly. Also fits rear radius ar...

A must-when the castor and camber angles are changed or whenever the geometry of the car is set up you will require these bushes. They are good for cars with up to 3.5 degrees of castor angle.

From November 2003 they have been made from a s...

Lower arm bush for pre 1966 cars. The lower arm had a straight hole whereas the later cars from 1966 on had a tapered hole and used 21A1882 bush with a metal sleeve in. This bush has no inner sleeve and it was discontinued in 1966. Sold ...

Mini Spares own to original drawing specifications with heat treatment correctly applied where appropiate.Lack of proper maintenance (grease) will make the pivot shaft and/or bearings wear that much faster. In severe cases the shaft may rust to the b...

Upgraded, lower EN8 damper pin. 3/8"unf. Sold singly

Especially useful for competion cars or street cars with lowered suspension.

Its quite a good idea to change these if they are corroded to give a better seating for your dampers.<...