£22.50 exc vat
£27.00 inc vat
Out of stock
£22.50 exc vat
£27.00 inc vat
Out of stock
In 1993 the moulding between the wheel arches was changed from black plastic to rubber and was still used on twin point rubber arches. This is the Minispares version which is a slightly more rounded profile.
Interior door pull handle with chrome end pieces, different to the mini but was offered by Rover as a replacement until we showed them the difference.
Originally fitted to MGB and the Austin 1100/1300 range it has 120mm bolt hole centre spac...
Rubber seal for all mini windshields. Uses locking strip 24A1466(chrome) or 37H8052(black.) REMEMBER YOU MUST FIT THE RUBBER TO THE BODY FIRST. DO NOT USE THE STRING METHOD BECAUSE IT STRETCHES AND TEARS THE RUBBER.
There is a later wider r...
Brake and clutch pedal pads contribute to comfort and safety. They also add that final touch to a nice interior. GPR104 fits brake and clutch pedals of MkI & MkII Minis up to 1976 and the throttle pedal on post 1976-1996 models.
Brighten up your car with these chromed plinths for the wiper wheel box on MK3 Minis on to the very last models. Includes 8 sided nut for all MK3 cars 1970 on.
For MK1/2 see 37H6042C.
Vinyl covered 9 piece black interior trim kit
This kit is for wind up window type doors,for MK3 saloons 1973 onwards (except Cooper S) and contains 2 door trims,2 rear quarter trims,rear parcel shelf,2 rear glove box trims and 2 rear wheel a...
Metal chromed old type classic handle revived for use on MG variants and then a fashion item on minis. On later cars CMZ312 screw might be required which has a smaller diameter head and longer thread. Length 90mm.
Black rubber bung to hold the bonnet prop in place on MK1/2 minis.
Also the same profile and shape as the rear boot board buffers but nearly twice the length at 1.5"(38.3mm).
Favourite old ashtray for MK1/2 minis with the fluted top for the rear glovebox and facia. Fitted to minis with painted top dash rail from 1959-85.
See 24A1538 also for flat lid version as fitted when top dash rail is vinyl cove...
Minispares original design and concept, many people have copied these but poorly, as ours are in stainless steel with nut fittings so they seal properly and cannot be stolen .If cleaned regularly they will stay smart and bright for a lifetime. Sold ...
8 sided nut for the Mk3 wiper wheel box (37H7200)from 1970 Mk1 were 6 sided and a different thread. Also fitted 1275 sprite and MG Midget with round body wiper motor.Sold singly 2 required per car
Chromed version of the standard demist vent on early cars where the ashtray is
mounted in the top and middle of the metal facia. Not for later cars with large
padded windscreen rails and ashtray in the front such as Mini Clubman and...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.