SILL LH VAN/TRAVELLER/PICK-UP MK1/2
MS57L

£21.00 exc vat

£25.20 inc vat

In stockIn stock

£21.00 exc vat

£25.20 inc vat

In stockIn stock

Recommended usage 1 x MS57L to fit one mini.

People also bought products

A post and inner wing repair panel 8" wide for Mk1/2 saloon and MK1 Van/pickup

L/H side-6" from A post section

Part inner wing L/H from Damper bracket mounting points forward. MK1/2/3 except Clubman. This panel has radiator cooling slats as fitted to 1991

NON genuine panel only as part panel

2-3" lower section of body section

from A post to rear wheel arch including the vital door step sill profile that rusts plus the horizontal edge that the chrome trim sits on-for cars with hinge type doors.

non genuine oversill MK1/2 van floor profile R/H with 4 flute vents

see MS58R for 6 flute type side, wide type

2-3" lower section of Van body section

from A post to rear wheel arch including the vital door step sill profile that rusts plus the horizontal edge that the chrome trim sits on-for cars with hinge tye doors

You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width with vertical flanges for easy installation and fairly well represent the original stamping. They have added metal to include...

You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width with vertical flanges for easy installation, and fairly well represent the original stamping. They have added metal to includ...

2-3" lower section of body section

from A post to rear wheel arch including the vital door step sill profile that rusts plus the horizontal edge that the chrome trim sits on-for cars with hinge tye doors

non genuine oversill MK1/2 van floor profile L/H with 4 flute vents see MS58L for 6 flute vents

Non genuine 11" long section repair panels equivalent to HMP441006 26" long genuine panel, the full length subframe mounting panel is HMP441008. This is the left hand side with castellated nut fittings for subframe

...

the A post repair panel with hole for coureousy light swith about 8" of metal below and above the hole, for external hinge door types

Non genuine 11"long section repair panels equivalent to HMP441006 26"long panel, the full length subframe mounting panel is HMP441008. This is the right hand side with castellated nut fittings for subframe

Although ...

the A post repair panel with hole for coureousy light swith about 8" of metal below and above the hole. External hinge type cars MK1/2 and vans etc.

Fits round tunnel cars. Approximate location of the vertical, forward wall is 17.5 - 17.75 inches back from the crease in the floor where the floor bends upward under the pedals. The forward wall lines up just forward of the front portion of the exte...

For Minis with sliding windows and external door hinges. These NON genuine R/H outer A panels fit over the extra inner panel which have brackets on to reinforce the exterior hinges. If the outside one is rotten you can guarantee ...

For Minis with sliding windows and external door hinges These NON genuine L/H outer A panels fit over the extra inner panel which have brackets on to reinforce the exterior hinges. If the outside one is rotten you can guarantee t...

Genuine Left hand front inner wing repair section with the radiator slats only -does not include the radiator shroud panel which is available seperately as 14A6498.

For Non Genuine half inner wing see CZH3065

Floor pan for Mini van/estate with no x member for remote change gearbox. Non Genuine. For saloon see 14A6491

picture is just to show what you get but bulge on centre tunnel for starter button appears to be on wrong side as this...

Aftermarket wings do the job at a fraction of the cost of originals. This right front wing for the Mini will fit all MKI, II, III, IV. A slight difference exists between the early and the later models as to headlamp mounting holes. These reproduction...