£36.16 exc vat
£43.39 inc vat
In stock
£36.16 exc vat
£43.39 inc vat
In stockRecommended usage 1 x MS58L to fit one mini.
outer sill panel for van and estate versions L/H from genuine tooling but we consider it a MK3 floor shape pressing
Non genuine section repair panels equivalent to MS51VAN. This is the left hand side with castellated nut fittings for subframe
For vans with metal load floors and pickups so match up before cutting out to much material
Non genuine section repair panels equivalent to MS51VAN. This is the right hand side with castellated nut fittings for subframe
For vans with metal load floors and pickups so match up before cutting out to much material
Non genuine repair panel for below the lights and above the rear valance, fits all models. Right hand side.
Small lower repair section of the rear quarter panel, if you need the door step section also see part number MS28R.
For Mk3 but can be used as a part of repair sectiion for Mk1/2
Small lower repair section of the rear quarter panel, if you need the door step section also see part number MS28L.
For Mk3 but can be used as a part of repair sectiion for Mk1/2
This Non genuine pattern panel has the holes for windscreen wipers and jets with barely an inch of pillar.
On cars from 1992/3 on check the original windscreen drain channel as the VIN numbers were stamped above the clutch master cylinder-wi...
Part inner wing L/H from Damper bracket mounting points forward. MK1/2/3 except Clubman. This panel has radiator cooling slats as fitted to 1991
NON genuine panel only as part panel
Non genuine L/H repair section
for wind up window type doors this is the lower 2-3" of the inner skin and the bottom of the door section that usually rusts out-includes a lip section where the outer skin flaps overlaps for fitment--new panel...
2-3" lower section of body section
from A post to rear wheel arch including the vital door step sill profile that rusts plus the horizontal edge that the chrome trim sits on-for cars with hinge type doors.
Aftermarket version of the L/H floorpan for 1991 on cars.
This floor was made stronger with smaller heel pad area to prevent vibration and rust and will fit any Rod change gear shift mini but was introduced on the first injection cars in 199...
A non genuine panel made for repairing the corner of the windscreen panel which is prone to rust from water splashing up from underneath the front wheel arch.
Experience has shown its easier to fit the genuine panel HMP441001 al...
non genuine oversill MK1/2 van floor profile R/H with 4 flute vents
see MS58R for 6 flute type side, wide type
2-3" lower section of Van body section
from A post to rear wheel arch including the vital door step sill profile that rusts plus the horizontal edge that the chrome trim sits on-for cars with hinge tye doors
You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width with vertical flanges for easy installation and fairly well represent the original stamping. They have added metal to include...
genuine rear lower back panel for MK2/3 on, which goes up as far as lower edge of backlight seal ridge
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.