£40.50 exc vat
£48.60 inc vat
In stock
£40.50 exc vat
£48.60 inc vat
In stockRecommended usage 1 x MS26LVAN to fit one mini.
Rear subframe mounting stiffener L/H repair bracket with holes for subframe mounting and attaches to wheel arch Fits on ALA8623
Body side rear lower w/arch to rear section of bodyside repair L/H. 220mm tall.
non genuine L/H outer MK3 door skin lower few inches repair section.
not as good a fit or looking as the genuine complete skinCZH3301
Non genuine repair panel for below the lights and above the rear valance, fits all models. Right hand side.
Aftermarket version of the rear R/H floorpan for 1992 on cars.
Appears to be a part section of the genuine whole length floor Right hand side.
This has extra length to go just under x memeber at 37.5"95cm long and under glove compar...
Non genuine rear valance closing panel with subframe mount repair
The rear valance of the Mini is a panel that is very often in need of replacing. While rear end damage can be a good reason, the most often cause is rust. The pane...
Non genuine rear valance closing panel with subframe mount repair
The rear valance of the Mini is a panel that is very often in need of replacing. While rear end damage can be a good reason, the most often cause is rust. The pane...
L/H narrow 6 flute outer sill for mk3 saloons to 2000 but most 1970 cars and Cooper S mk3 had 4 flutes--Great quality and fitting aftermarket panel
This Non genuine pattern panel has the holes for windscreen wipers and jets with barely an inch of pillar.
On cars from 1992/3 on check the original windscreen drain channel as the VIN numbers were stamped above the clutch master cylinder-wi...
The rear lower side and rear corner panel for the Mini Van, Pick-up and Estate are all the same. This repair panel is intended to be spliced in to replace a most often rusted spot!
Commercial Mini floor extension
It is an essential part for the correct restoration of all the longer wheelbase mini derivatives. From the original tooling.
NON genuine 8"wide outer sill for the van/pick up and estate range with MK3 square pressings. No genuine wide panel is available but see 14A9026/7 for 4" wide panel which actually covers only 2.5" of actual lower floor pan whereas the non genuine pan...
A non genuine panel made for repairing the corner of the windscreen panel which is prone to rust from water splashing up from underneath the front wheel arch.
Experience has shown its easier to fit the genuine panel HMP441001 al...
non genuine oversill MK1/2 van floor profile R/H with 4 flute vents
see MS58R for 6 flute type side, wide type
2-3" lower section of Van body section
from A post to rear wheel arch including the vital door step sill profile that rusts plus the horizontal edge that the chrome trim sits on-for cars with hinge tye doors
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.