REAR FLOOR PAN RIGHT HAND NON GEN 1992 ONWARDS
MSL26R

£52.50 exc vat

£63.00 inc vat

In stockIn stock
Aftermarket version of the rear R/H floorpan for 1992 on cars.

Appears to be a part section of the genuine whole length floor Right hand side.

This has extra length to go just under x memeber at 37.5"95cm long and under glove compartment-one deeper groove for wiring/pipes? and the MS26R pre 1991 floor has glove box cut outs and only 31.75"(80.5cm) long.It would appear that this is an under panel whereas the early MS26 is an over/fits inside panel.

£52.50 exc vat

£63.00 inc vat

In stockIn stock

Recommended usage 1 x MSL26R to fit one mini.
Saloon Floor Panels - Qty 1

People also bought products

Rear subframe mounting stiffener L/H repair bracket with holes for subframe mounting and attaches to wheel arch Fits on ALA8623

Rear subframe mounting stiffener panel R/H with holes for subframe mounting to wheel arch. Sits on ALA5524 or ALA5528

Metal floor plug as per original with rubber seal.



For use in 1" hole.

Body side rear lower w/arch to rear section of bodyside repair L/H. 220mm tall.

Non genuine L/H saloon inner sill. Only made as an after market replacement as no genuine part was ever available seperately. Best one on the market for a comlplete inner sill replacement panel. With carpet fix brackets.

Non genuine R/H saloon inner sill. Only made as an after market replacement as no genuine part was ever available seperately. Best one on the market for a complete inner sill replacement panel. With carpet fix brackets.

Non genuine repair panel for below the lights and above the rear valance, fits all models. Right hand side.

Non genuine repair panel for below the lights and above the rear valance, fits all models. Left hand side.

Front A panel part of door frame with door stay hole for internal hinge cars right hand non gen.

Aftermarket version of the rear L/H floorpan for 1992 on cars with cuved shape for tunnel.

Appears to be a part section of the genuine whole length floor Right hand side.

This has extra length to go just under x memeber at 37.5"95cm...

Non genuine rear valance closing panel with subframe mount repair



The rear valance of the Mini is a panel that is very often in need of replacing. While rear end damage can be a good reason, the most often cause is rust. The pane...

Non genuine rear valance closing panel with subframe mount repair



The rear valance of the Mini is a panel that is very often in need of replacing. While rear end damage can be a good reason, the most often cause is rust. The pane...

L/H narrow 6 flute outer sill for mk3 saloons to 2000 but most 1970 cars and Cooper S mk3 had 4 flutes--Great quality and fitting aftermarket panel

Small lower repair section of the rear quarter panel, if you need the door step section also see part number MS28R.

For Mk3 but can be used as a part of repair sectiion for Mk1/2

Small lower repair section of the rear quarter panel, if you need the door step section also see part number MS28L.

For Mk3 but can be used as a part of repair sectiion for Mk1/2

This Non genuine pattern panel has the holes for windscreen wipers and jets with barely an inch of pillar.

On cars from 1992/3 on check the original windscreen drain channel as the VIN numbers were stamped above the clutch master cylinder-wi...

Non genuine L/H repair section

for wind up window type doors this is the lower 2-3" of the inner skin and the bottom of the door section that usually rusts out-includes a lip section where the outer skin flaps overlaps for fitment--new panel...

2-3" lower section of body section

from A post to rear wheel arch including the vital door step sill profile that rusts plus the horizontal edge that the chrome trim sits on-for cars with hinge type doors.