Metal floor plug as per original with rubber seal.



For use in 1" hole.

Aftermarket version of the rear L/H floorpan for 1992 on cars with cuved shape for tunnel.

Appears to be a part section of the genuine whole length floor Right hand side.

This has extra length to go just under x memeber at 37.5"95cm...

You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width with vertical flanges for easy installation and fairly well represent the original stamping. They have added metal to include...

The crossmember holds the seat brackets and has the correct shape on the bottom to sit correctly on the floor of the rod change tunnel only. This is the complete section from inner sill one side to the other. Fits all square type rod change gearbox f...

Every mini saloon has these,2 of 24A41 on either side front and 24A42 /24A43 sided on the rear --only purpose was for building/moving/ storing and preparation of cars at the factory to sit them on ..Also acted as a stiffener...

rear fog lamp bracket which attaches to the rear valance -right hand drive only.

If you have fitted the old type overiders and corner bars for the Retro look you will need to fit a modified bracket MSS024 which is basically the left hand dri...

outer sill panel for van and estate versions r/h from genuine tooling but we consider it a MK3 floor shape pressing-6 flute indentations 6 flute indentations

This 9.5" rear section of the boot (trunk) floor is ideal for collision or rust repair. Many times if you are hit from the rear the floor right in front of the bumper gets damaged-this will fix it. If rust is your problem, then this along with a new ...

MK1/2 toe board with steering rack mounts.

MK1 front bulkhead skin to suit mk1 with the round hole for the heater trunk pipe. Bonnet hinge brackets not fitted.



Can be used in later models with some adaption.