The Cooper S had these mouldings and this is the same item but made for the MK3 wind up window cars. These are easy to install, drill 1/8" holes evenly spaced on the straight edges,3 each side and 4 at the top(not on any corners)of the window frame.T...

A pair of upper door frame mouldings to make your car look like the original Cooper S---For wind up window doors only they really finish of the door frames around your door glass----with fitting clips-doors will have to be drilled but a simple job wi...

One of the distinguishing features of the Cooper S model was the chrome trim around the door windows. If yours is missing or mangled, it can now be replaced

(we won't ask for your car's pedigree if you're adding it to a non S door)! These fi...

High quality non genuine door check strap for MK3 cars with wind up window doors (use with retaining pin CLZ412). Beware there are cheap copies on the market that are poor quality and when fitted to our cars did not function correctly!

Angled spacer washer for Mk1/2 external door hinge cars for the upper hinge

Door hinge shim for all wind up window cars, these are used to align the doors, 1.2mm thick and made in stainless steel use, with ALA6383 to get good door alignment See ALA6381 for thicker rear support plate.

A great accessory for wind up window minis. Fitted in minutes to make such a difference driving your Mini with the window open. Wonderfull for those that smoke or love fresh air. In a tinted colour to stop bad reflections.

Twin point injection cars had a split seal system door frame seal for the front doors,the lower acting as a shield cover for the trim. fitted from chassis no BD134455 ON

Some customers have replaced it by the one piece CGA2835MS<...

Special lower seal--fitted to MPI cars from October 1996 show cars chassis no BD134455 ON

Has a lip on inner edge to hold carpet back and tidy internal trim but other than that the CGA2835MS will fit --the full set is

Genuine Mini Spares mouldings product as supplied to Rover.

These are the later door mouldings that prevent water running down the windows into the door causing rust and have the black platic ends fitted for later car safety regulations but ...

The Cooper S had these mouldings and this is the same item but made for the MK3 wind up window cars. These are easy to install, drill 1/8" holes evenly spaced on the straight edges,3 each side and 4 at the top(not on any corners)of the window frame.T...

Sponge type seal on R/H A post of all minis with wind up window type doors to protect from water running down into body. A part you must keep your eye on to stop rust, if the sponge is gettig hard then replace it.

Holds the window regulator to the door on wind up window minis from 1970 on.

Also holds fog lamp bracket to rear valance. 1/4" unf with 1/2" thread on

panhead type screw.