£22.80 exc vat
£27.36 inc vat
In stock
£22.80 exc vat
£27.36 inc vat
In stockRecommended usage 1 x MSA337 to fit one mini.
Wiper Swithch MK1/2/EARLY MK3 blade type switch for using to convert to 2 speed wipers when current 2 speed wiper motor is used.
Originally fitted as standard to the MGB and MGB GT, but has the same plug configuration as the 76 on Mini's so can be used in place of the stabdard rocker switch
If you also have an issue with the plug, a new plug and wiring repair is avail...
Rocker switch for all models with front fog lights fitted as standard. Please note the lens colour is now green. 6 pins on the back for plastic loom connector.
Fitted under the bonnet on top of the servo. Relay for the engine management on twin point cars only from 1996-except for cars with air conditioning which use YWB101080.
On /Off safety swith guard and press starter switch,a red safety light --See MSA337 for extra swith and light, no wiring included.
Rear fog lamp switch with the orange illumination segment for all vehicles fitted with production fog lamps as standard. 3.1cm tall from 1976 on.
Mk1 Mini Indicator stalk green lens. Also fitted to other BMC variants such as Morris Minor. See GLB280 for the replacement bulb
IGNITION BARREL TO FIT 13H337 SWITCH. MK1/2/EARLY MK3. ONE BARREL,TWO KEYS
circuit breaker for safety as required in motorsport
The switch has to be accessible from inside and outside the car.The external trigger should be located on the windscren scuttle panel -preferably the drivers side . It should be clearly ma...
MK1/2/EARLY MK3. 3 position spring loaded type. Comes with barrel.
For barrel only use part number 24G1345.
Headlamp switch fits MK1/2/ earlyY MK3, Toggle type also known as bat handle type, 3 POSITION. BLADE CONNECTIONS.
Battery cut-off switch. FIA approved
Most race sanctioning bodies require the use of this special (diode protection device) cut out allowing the switching off whilst the engine is running without damaging the electrics. The switch has to be ...
This switch fits under the brake pedal on the floor. See also BMK1903A locknut for this item.
Single speed heater switch for MK3 cars from1970 to 1996 only, as Rover changed to a twin speed heater fan with a new switch YUF101410.
This is the only part available for the heater control panel now..
Quantity requir...
Rectangular switch for the rear heated screen with pin connectors plus a spade type. 3.1cm tall, from 1976 on.
HAZARD WARNING SWITCH, PIN TYPE CONNECTORS. MK4 FROM 1976. 3.1cm tall.
LIGHT SWITCH MK3 ILLUMIN, currently in short supply use YUF101030
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.