STARTER SAFETY PANEL PUSH BUTTON TYPE AND LIGHT
MSA343

£34.72 exc vat

£41.66 inc vat

In stockIn stock
Make your classic a little bit safer and racier with these rally type ignition switches.One of these mounted on your dash board will allow you to flick the red cover up, click the switch down and then thumb the button to kick the engine into life. Th...

£34.72 exc vat

£41.66 inc vat

In stockIn stock

Recommended usage 1 x MSA343 to fit one mini.

Alternative products

On /Off safety swith guard and press starter switch,a red safety light --See MSA337 for extra swith and light, no wiring included.

People also bought products

Courtesy switch for MPI minis from 1996 when the wiring was changed from bullet type to spade connection. This is the switch that fitted into the A post to turn the interior light on and off, the earlier switch is no longer available so if you have a...

Rocker switch for all models with front fog lights fitted as standard. Please note the lens colour is now green. 6 pins on the back for plastic loom connector.

On /Off safety swith guard and press starter switch,a red safety light --See MSA337 for extra swith and light, no wiring included.

If you have a floor mounted type of headlamp dip switch then this is the item you require.Mk1 Mini--sprite/midget MGB67-70,morris Minor.landrover,bentley, rolls and many more.

circuit breaker for safety as required in motorsport

The switch has to be accessible from inside and outside the car.The external trigger should be located on the windscren scuttle panel -preferably the drivers side . It should be clearly ma...

MK1/2/EARLY MK3. 3 position spring loaded type. Comes with barrel.

For barrel only use part number 24G1345.

Headlamp switch fits MK1/2/ earlyY MK3, Toggle type also known as bat handle type, 3 POSITION. BLADE CONNECTIONS.

WIPER SWITCH,FITS MK1/2/EARLY MK3.TOGGLE TYPE.2 POSITION.

Battery cut-off switch. FIA approved

Most race sanctioning bodies require the use of this special (diode protection device) cut out allowing the switching off whilst the engine is running without damaging the electrics. The switch has to be ...

This switch fits under the brake pedal on the floor. See also BMK1903A locknut for this item.

A low oil pressure warning light switch is available to help protect the engine. The standard one comes on at 7lb-much too late to avoid damage. This one comes on at 20lb and is adjustable up to 120lb. Please note this is now a twin terminal switch, ...

Also known as brake failure switch, MK4 From 1976.

HAZARD WARNING SWITCH, PIN TYPE CONNECTORS. MK4 FROM 1976. 3.1cm tall.

Relay for horn, front spotlamps, fogs, starter indicators, alarm, cooling fan, burlar alarm and oxygen sensor - The relays for the electrics appeared from about 1990 on and all single point injection cars and SOME are colour coded for ease-40 amp wit...

Economy battery cut-off switch.

Most race sanctioning bodies require the use of a kill switch for easy and complete cut-off of power from the battery. The switch has to be accessible from inside and outside the car; the external trigger...

A must for performance cars or custom cabs these switches have an LED light in the end for seeing in the dark

A must for performance cars or custom cabs these switches have an LED light in the end for seeing in the dark

A must for performance cars or custom cabs these switches have an LED light in the end for seeing in the dark

This part often fails and if the conection points look dodgy replace the socket 520161 which also has a small loom.