£415.09 exc vat
£498.11 inc vat
Out of stock
£415.09 exc vat
£498.11 inc vat
Out of stock
Our lightweight underfelt kit is the perfect companion when fitting a new headlining. Made from lightweight felt and cut to size, this fits into the cavity of the roof before fitting your new headlining and provides increased sound insulation and pro...
The chrome moulding to fit the door bin on first 80 thousand MK1 minis with extra length tag with screw hole for location.
This is held on by screws but a single sided prong clips ADH3809 can be used in the centre - beware other...
Headlining kit including C post trims in cream crackle for 67-69 Minis which have a larger rear screen.
Cream colour crackle finish sun visor as fitted from december 1965 onwards. Will fit later cars if required. Drivers side without mirror.Check out the special clips to hold these visors as they are sold seperately in car sets only as SV2021<...
This chromed bracket is to secure the early Mini sunvisor with the central location.
1959-64 visors had one central hinge and in October 1964-65 they fitted a sunvisor with a hinge one end and clip fixing the other-this is when the first pla...
This was the first style of sunvisor pad with central pivot point in cream crackle finish used on the early Minis.Some very early minis used pale grey for std but all Supers had crinkle finish cream to match headling. For this period the Cream Crackl...
Full carpet boot liner kit, completely lines the inside of the boot area.
Not suitable for MPI minis.
boot board 32" wide for early cars with smaller 5.5 gallon tank
127cm long and 43cm wide this is enough leather cloth trim that fitted S and deluxe models on the upper and lower facia plus the winscreen A posts. Fitting instructions are included but no glue.
The metal retainer that holds the rod change gear lever gaiter CZH4278 in place
Reproduction gear lever gaiter for all remote control type gearboxes with the short gear lever by the driver's seat. The metal retainer for this gaiter is 14A9942. These were fitted until the introduction of the rod change type [link]CZH...
This kit contains all the brackets and mounts that were fitted on to the floor on original Coopers, Wolseley Hornet and Riley Elf with boot boards fitted as standard.
This kit does not include the bracket on the boot board 14A9783
Favourite old ashtray for MK1/2 minis with the fluted top for the rear glovebox and facia. Fitted to minis with painted top dash rail from 1959-85.
See 24A1538 also for flat lid version as fitted when top dash rail is vinyl cove...
A bit larger than the MK1 to accept the improved indicator switch this fitted
MK2 and MK3 cars until the introduction of the steering locks.
Original type MK1/2 door strap in Dark grey(darker than cumulus grey and dove grey was slightly lighter again)
Check straps matched seat colours or outer main seat colour on two tone types
ALE1221 Black
[link]1...
Seal for door handles MK1/2 and all sliding window exterior hinge cars.
also used on 14A7195 mk1 boot handlle used on mk1/mk2 and van/estate
is oval shaped
for boot / rear door use the hole at the rear ...
Chromed version of the standard demist vent on early cars where the ashtray is
mounted in the top and middle of the metal facia. Not for later cars with large
padded windscreen rails and ashtray in the front such as Mini Clubman and...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.