£3.00 exc vat
£3.60 inc vat
Out of stock
£3.00 exc vat
£3.60 inc vat
Out of stock
Bayonet bulb with small glass for use on special fitments such as mini clubman indicators and many headlamps as pilot or sidelight bulb. 4 watt 12 volt slim glass head same size as bulb body.
2.2 WATTS and fits back of gauges in cars with 3 extra 52mm round clocks.
Screw type bulbs that fit the plugs (AEU1313A) on the round central clock speedos on all minis from 1959 until the introduction of the non Smiths type plastic clocks as used on the first clubmans and 1275GT. Sold individually.
Bayonet bulb with small glass for use on special fitments such as mini clubman indicators and many headlamps as pilot or sidelight bulb. 4 watt 12 volt slim glass head same size as bulb body.
If you have quadoptic headlamps these are the blue bulbs for an upgrade in lighting. Sold individually.
Headlamp bulb for the 700 series LHD and for Cibie.Sold individually
This chrome over brass wing side repsater lamp rim will fit of the square/oblong lamp lens where fitted on the wing. Fits straight over the original lens and retained by bending the tag. Made in brass to prevent rusting, but also to obtain that deep...
For wipac quadoptics-replacement bulb holder for lamps also supplied in kit.
Even at normal highway speeds it is common to "outdrive" conventional headlamps. The halogen headlamps have very bright 55/60 watt bulbs. Their special lens gives g...
The best chrome type available with screw and washer.
A headlight trim ring is only the starting point of a good looking car, but you have to start somewhere. Sold singly 2 required per car. These are the original type chrome over solid bras...
Almost any screw will hold the chrome headlamp bezel on, but only one is correct! These screws are stainless steel and will never corrode plus they have the little rubber washer on the backside so that the screw will not fall out when trying to fit ...
Two of these plastic lens that hold festoon bulbs (GLB239) are mounted in the metal cast number plate housing (13H6900) on all MK3 bootlids from 1970on. Sold individually with bulb LESS FIXING SCREWS.
See PMZ206 for screw replac...
All Minis require an earth strap from the engine to the body and from 1959-1996
they fitted from the gearbox to the subframe. When they introduced the twin point in 1996 it was moved to the upper engine stabiliser arm. About 13"LONG.
This front turn lamp assembly was used on all Mkl & Mkll Saloons, all Vans and Pick-Ups. It is also an easy installation on later cars seeking that proper sixties look. Includes amber glass lens, chrome surround and rubber boot. The clips to hold thi...
Domed shape indicator lamp for all minis with single filament bulb, this is the aftermarket type with a plastic orange lens but if you are looking for the original glass lens type see 2A9013. Fitted up to 1986 and the clips that fit the ...
Plastic bulb holder for the wing side mounted flasher on cars from 1986 on--
make sure you change the seal AFU3112 when you dismantle these to stop water corrosion. sold singly, 2 per car required.
The headlamp bucket is isolated from the body with these rubber seals/gaskets.
Headlamp sundries kit.
Includes two adjuster screws, plastic nutserts, pullback spring. Two kits are required per car.
This is the wiring short conversion loom that fits to the old central speedo and is used by people modifying from 2 or 3 clock dashes to single clock or just repairing damaged looms. With the correct bulb holders and spade fittings. Now uses 5x [link...
One pair of plastic covers to go over your original Rover spotlamps with Cooper laurel motif.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.