£53.66 exc vat
£64.39 inc vat
In stock
This squab was used exclusively on minis 1985-1992 before the introduction of moulded seats.
Has a split in the middle which a calico flap is pulled through when fitting the squab covers to give a tight finish.
Not always stocked but ordered for customers requirements
Instructions
SHOULD BE GLUED TO THE SEAT FRAME
£53.66 exc vat
£64.39 inc vat
In stockRecommended usage 2 x SF3020 to fit one mini.
This is the diaphragm for the seat squab, the part your back sits against on cars from 1960-92 pre headrest types with twin posts
Auto retractable seat belt kit. Sold per seat. The manufacturer states that these belts are direct replacements for the inertia reel type fitted from 1976 including the later pre tensioner type. Not suitable for MK1/2 saloons and vans/pickups due to...
Auto retractable seat belt kit. Sold per seat. The manufacturer states that these belts are direct replacements for the pre tensioner types fitted in Europe.
It will arrest the wearer within the same tolerances without a need for a
Front seat base foam.This cushion can be used for most models with single pole headrest from 1985-92 before the introduction of moulded seats. It is approx. 2" thick with raised sides and deeper version of SF3010 which it replaced to giv...
MODERN TYPE FOAM CUSHION CUT PRECISELY TO SHAPE READY TO RECEIVE NEW SEAT COVER.FOAM IS READY TO ACCEPT NEW SEAT COVER WHICH IS GLUED TO THE TOP SURFACE, THEN THE SEAT SKIRTS ARE TURNED OVER THE EDGES AND AGAIN GLUED IN PLACE. SUGGEST CHEMICAL BASED ...
Fitted to all saloons of this period. Shaped to the original design but made in modern day specification foam. The cushion is placed over the rear seat frame and the turned ends glued to follow the shape of the frame. The seat cover is then situated ...
This wire strap type was fitted from 1974 as standard, but this will fit all minis from 1959 to 1995. 36cm x 29.5cm
Also used for other trim areas this clip holds the vinyl or fabric of the seat covers to the metal framework.This part has larger D shape and claw spikes but if you want the smaller D shape and claws for headlining and rear seat covers see[link]14A80...
The clips that hold the seat squab vinyl to the frame on front seats and the headlining. These clips are available seperately as GHF1500.
Car set (one pair) rear wheel arch vinyl trim covers.
Original MK1/2 finer grain wheel arch cover-heavier grain pattern is WAC3025A although not much diffferent and never noticed.
Multi purpose square plastic plug/nut for No8 screw size was used on many door fixings and fuse box to body.
Also suitable for Twin Point indicator fixings.
127cm long and 43cm wide this is enough leather cloth trim that fitted S and deluxe models on the upper and lower facia plus the winscreen A posts. Fitting instructions are included but no glue.
This is the chrome screw that fits the 14A8151 catch boss on sliding window minis. Also fits the door winder handle on early wind up window cars.
For 7.5 gallon petrol tank cars this is 29" wide with one corner cut. If you are looking for an alternative to this carpet covered wood boot floor, try our plastic load liner EBF100150
Vinyl covered 9 piece black interior trim kit
This kit is for wind up window type doors,for MK3 saloons 1973 onwards (except Cooper S) and contains 2 door trims,2 rear quarter trims,rear parcel shelf,2 rear glove box trims and 2 rear wheel a...
Four tailor made felt pieces to fit in the segments between the bonnet strengthening webs to allow maximum under bonnet clearance.
See FELT860 for spray adhesive. These are about 1cm thick and the original very thick sound dea...
Moulded black carpet set for Rod change change with soundproofing attached where appropiate.
These fit correctly and snugly in your car over the tunnels etc for that professional look. 2 rubber front foot pads and on rear carpet has reinforc...
Chromed version of the standard demist vent on early cars where the ashtray is
mounted in the top and middle of the metal facia. Not for later cars with large
padded windscreen rails and ashtray in the front such as Mini Clubman and...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.