STARLOCK WASHER FOR MK3 DOOR HANDLE SCREW
WE702101

£0.08 exc vat

£0.10 inc vat

In stockIn stock

£0.08 exc vat

£0.10 inc vat

In stockIn stock

Recommended usage 1 x WE702101 to fit one mini.

Kit products

MK3 Door & boot handle fitting kit, including original type screws, star washers and gaskets.

People also bought products

MK3 Door & boot handle fitting kit, including original type screws, star washers and gaskets.

Key barrel set for Mk3 onwards door handles and boot handles.

For wind up window type doors this is the mini saloon and clubman estate r/h

door lock mechanism mounted on the door.

For wind up window type doors this is the mini saloon and clubman estate l/h

door lock mechanism mounted on the door.

A complete set of 2 front door and one boot handle in chrome all with the same key numbers for wind up window door minis 1970on (keys included).

Door Handle Gasket's should also be replaced at same time, CZH1729 and [link]ALA579...

If your MKI or MKII suffers from terminal "door handle sag" it is quite possible that the inside door latch mechanisms are tired. A left hand drive car should have a locking latch on the right side (the driver's side key-locks with the handle). Right...

If your MKI or MKII suffers from terminal "door handle sag" it is quite possible that the inside door latch mechanisms are tired. A left hand drive car should have a locking latch on the right side (the driver's side key-locks with the handle). Right...

Seal for door handles MK1/2 and all sliding window exterior hinge cars.

also used on 14A7195 mk1 boot handlle used on mk1/mk2 and van/estate



is oval shaped



for boot / rear door use the hole at the rear ...

The door striker plate on the B post holds the door shut, but the nylon guide block 14A6833 actually supports the weight when the door is closed. When one wears it typically takes the other with it, so replace both. Don't forget to order...

clip that sits on the activating lever on the bottom of the MK3 door handle itself.

New door handles CZH886 and CZH887 have this clip on already.

On sliding window type MK1/2 doors the door locks are held on by these 3 screws.

3/16"unf countersunk head 1" long.

Clip to connect the door opening remote control rod plus the lock control mechanism fits on CZH640/1 and CZH616/7-- 2 per door. Also fits the wastegate on turbo models.

High quality non genuine door check strap for MK3 cars with wind up window doors (use with retaining pin CLZ412). Beware there are cheap copies on the market that are poor quality and when fitted to our cars did not function correctly!

Mini Spares own MK3 Window drop rail kit includes 1 x ALA5746SS AND1 x ALA5747SS plus 2 x 24A948 seals for the drop rails to hold the glass, this kit will do one complete door only.

The gasket that sits behind the door stiker on all wind up window type minis

on the B post.

Complete fitting kit for the door check straps on all Minis fitted with external hinges.

Angled spacer washer for Mk1/2 external door hinge cars for the upper hinge