Showing 1 to 20 of 42

They changed the yellow indicator lens in late 1986 to this type which is held on by 2 screws (GFK2257). If you want to change to white as fitted standard on twin points then use CDU3374W but remember to change the bulb to a...

Fits on the bulb holder of the wing square side flasher/repeater lamp.

Bulb holder is DCP8004, orange bulb is GLB501A, white bulb is GLB501. sold singly,2 required per car

White version of CDU3374 held on by 2 screws (GFK2257) now commonly fitted which be came standard on twin points, but beware as the MPI lamp was different and used an offset pin bulb GLB344. Pre twin point lamp ...

For customers who wish to colour code their light lens, this smoke(grey) lamp is for the small square side lamp on the wing fitted from 1986. Sold singly

This will replace the orange lens fitted on the wing of all cars from 1986 on, but must be fitted with an orange bulb in the UK. Rover fitted this to the twin point injection range from 1996 on. If you need a new loom for this lamp see AFU33...

The "Beehive" red glass lens are used throughout the British car range! (front overseas and rear everywhere). Available in various colors: This is the Red Glass----

for clear se 37H6928 and for amber see 37H5520

This rubber boot covers the indicator/turn signal housing inside the fender. Fits the Mini and it's the same front & rear for the Bugeye sprite and various other British cars.

Domed type clear/white plastic lens for use on lamps where the lens is held in place by the rubber boot and metal rim, see 37H6928 for original glass type.Sold singly 2 required per car

Original glass clear lens lamp with twin filament bulbholder, front side and indicator lamp that was usually fitted on USA or export models.

UK cars had just a single filament indicator with amber lens. These are complete assemblies includi...

This is the Non Genuine twin filament front side and indicator lamp with a clear plain plastic lens glass that was usually fitted on USA or export models. UK cars had just an amber single filament indicator with amber lens. These are complete assembl...

Upper amber R/H lens for MK1 mini saloon. The lower red part is 47H5363. See 47H5360 screw kit also for the special screws.

Glass "beehive" lenses, either clear or amber, were used on the front turn signals on MKI and MKII Minis. For best colour match they should be replaced in pairs. Part 37H6928 is clear, 37H5531 is red.

Sold singly 2 ...

Domed amber lens in plastic was used on the indicators of all minis and other BMC/Leyland cars the same size as the white lens used on alternative vehicles.

If you change to white remember to fit orange bulbs. If you require the original gla...

This is the original correct colour orange (amber) lens for the side repeater lamp on the wing fitted up to the twin point cars which had white.

A white lens AHU2592W is available and fitted to 1996 on cars but remember to fit a...

INDICATOR LAMP WITH WHITE LENS LESS BULB. sold singly,2 required per car

The outer white lens is the same as used on the conversion of the orange type used on 1986-1996 cars but the body was different on twin point cars and used a safety plug. The white lens if broken is moulded in the body but can be cleaned out complete...

The "Beehive" lens are used throughout the British car range! (Front and rear). Available in various colors: Clear (frosted) GLASS.


Glass "beehive" lenses, either clear or amber, were used on the front turn signals on MKI and MKII Minis...

This is the side repeater lamp that first appeared on the Mini Special in 1989

and on some special edition minis and the ADO16 model Austin, Morris and MG 1100/1300. The later 1986 cars had the square lamp PRC9916A fitted.

INDICATOR LAMP WITH ORANGE LENS BUT LESS BULB. Sold singly, 2 per car

This is the white lens kit for cars that have side repeater lens on the wing and earlier indicator lens that were held in by the chrome ring. Pre MSSK28 type

for about 1 year from 85-86 during cross over period where front indicator lamp the...

1 2 3