Showing 1 to 20 of 187

This is the lower right hand clear lens with a small red reflector fitted to all Lucas type lamps on saloon cars from 1976 on which also had rhe reverse light incorperated in it. But as they are so big they also seems to be hit first! If you have c...

This is the lower left hand clear lens with a small red reflector fitted to all Lucas type lamps on saloon cars from 1976 on which also had the reverse light incorperated into it.

Fitted RHD cars before the introduction of self levelling lights.

This is a complete unit with chrome outer rim but if you have the wiring an alternative is to use S5400 bowl with XBC104430

Fitted to twin point injection cars and a few single point (mostly export)with self levelling function complete less headlamp rim--See 500929ms in stainless steel for rim or 17H5143 for chrome over brass. Comes complete with foam seal. I...

They changed the yellow indicator lens in late 1986 to this type which is held on by 2 screws (GFK2257). If you want to change to white as fitted standard on twin points then use CDU3374W but remember to change the bulb to a...

Bulb for the genuine spots on SPI and MPI cars -usually ordered to customers request.

Single replacement unit for the right hand drive kit S4698B with left hand dip



lamp part only, does not include the rubber cover, bulb or side light part

Fits on the bulb holder of the wing square side flasher/repeater lamp.

Bulb holder is DCP8004, orange bulb is GLB501A, white bulb is GLB501. sold singly,2 required per car

These plugs are for the 3/8" holes in the front panel where the spot or foglamp brackets would be fitted, on late front panels.

For MK2 rear lamps without reverse lamp features this fits between the lamp body and the lens. Not sided.

Set of three screws to hold the lens for the MK1 rear lamp.

These stainless steel peaks fit under the headlamp rim to give that old 60s style again.

White version of CDU3374 held on by 2 screws (GFK2257) now commonly fitted which be came standard on twin points, but beware as the MPI lamp was different and used an offset pin bulb GLB344. Pre twin point lamp ...

Same size fitting as the regular indicator bulb GLB382 but only 5 watts with small glass head.

This plastic bowl kit includes the inner rim to hold your light unit and will obviously not rust like the old originals. You will need a headlamp outer rim so why not fit our own developed stainless steel variety which is cheaper than even chrome bud...

Late model cars have these bright red auxiliary "safety lights" mounted below the rear bumper. They are to be switched on during inclement weather. Upgrade for your safety, a legal rquirement on late cars.

For customers who wish to colour code their light lens, this smoke(grey) lamp is for the small square side lamp on the wing fitted from 1986. Sold singly

This will replace the orange lens fitted on the wing of all cars from 1986 on, but must be fitted with an orange bulb in the UK. Rover fitted this to the twin point injection range from 1996 on. If you need a new loom for this lamp see AFU33...

The special clip to hold the indicator lamp to the body. Used on all pre 1996 minis. Sold individually, 6 per car.

The "Beehive" red glass lens are used throughout the British car range! (front overseas and rear everywhere). Available in various colors: This is the Red Glass----

for clear se 37H6928 and for amber see 37H5520

Arrow next
1 2 3 4 5 ...