FLOOR PAN ROD CHANGE L/H FRONT TO REAR
HMP441005

($150.00) £150.00 exc vat

($180.00) £180.00 inc vat

In stockIn stock
This front to rear rod change floor pan is based on the last type of floor pan used where a large stiffener gusset went down the length of this panel to house the extra injection fuel lines which disected the front footwell tray making it very strong.This has 6 flute indentations as used from 1970 on but includes half the rod change tunnel which can be removed for earlier cars-we also stock earlier 4 flute floor pans without any tunnel as per MK1/2 cars. FS006R and L

($150.00) £150.00 exc vat

($180.00) £180.00 inc vat

In stockIn stock

Recommended usage 1 x HMP441005 to fit one mini.
Saloon Floor Panels - Qty 1

Alternative products
FLOOR PAN FRONT TO REAR L/H PRE 1990
FS006L

floor pan front to rear for the left hand side only to the correct floor shape before 1990-1 rib design change---ideal for MK1/2 restoration with original 4 flute indentation. This has the carpet stud brackets plus underside slinger bracket and mul...

($90.00) £90.00 exc vat

($108.00) £108.00 inc vat
People also bought products
DOOR CHECK L/H PANEL GENUINE
ALA6473GEN

L/H Inner hinge type A post repair panel with hinge fitting holes mini, MK3

this is a genuine heritage part.

($32.00) £32.00 exc vat

($38.40) £38.40 inc vat
DOOR CHECK R/H PANEL GENUINE
ALA6472GEN

R/H Inner hinge type A post repair panel with hinge fitting holes mini, MK3

this is a genuine heritage part.

($32.00) £32.00 exc vat

($38.40) £38.40 inc vat
WINDSCREEN LOWER SCUTTLE PANEL NON GENUINE
HMP441001MS

This Non genuine pattern panel has the holes for windscreen wipers and jets with barely an inch of pillar.

On cars from 1992/3 on check the original windscreen drain channel as the VIN numbers were stamped above the clutch master cylinder-wi...

($44.85) £44.85 exc vat

($53.82) £53.82 inc vat
FLOOR EXTENSION PANEL FOR MINI VAN/ESTATES ETC
14A9023

Commercial Mini floor extension

It is an essential part for the correct restoration of all the longer wheelbase mini derivatives. From the original tooling.

($100.00) £100.00 exc vat

($120.00) £120.00 inc vat
WINDSCREEN CORNER PANEL L/H
MS6L

A non genuine panel made for repairing the corner of the windscreen panel which is prone to rust from water splashing up from underneath the front wheel arch.

Experience has shown its easier to fit the genuine panel HMP441001 al...

($16.88) £16.88 exc vat

($20.26) £20.26 inc vat
FRONT FLOOR PAN L/H PRESHAPED
MS25L

You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width with vertical flanges for easy installation and fairly well represent the original stamping. They have added metal to include...

($33.00) £33.00 exc vat

($39.60) £39.60 inc vat
FRONT FLOOR PAN R/H PRESHAPED
MS25R

You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width with vertical flanges for easy installation, and fairly well represent the original stamping. They have added metal to includ...

($33.00) £33.00 exc vat

($39.60) £39.60 inc vat
GUSSET CLOSING PANEL R/H
14A8348

THIS PANEL PROTECTS THE UNDERSIDE OF THE WINDSCREEN VALANCE UNDER THE FRONT WING SECTION also fitted on the inner wing panel 14A8346/7

($15.00) £15.00 exc vat

($18.00) £18.00 inc vat
DASH RAIL UPPER METAL PANEL WITH ASHTRAY APERTURE
14A6675

This panel has mounting holes for later models facia crash panel. These holes will require blanking for true originality on earlier models without the facia pad

($55.00) £55.00 exc vat

($66.00) £66.00 inc vat
FLOOR PAN FRONT TO REAR L/H PRE 1990
FS006L

floor pan front to rear for the left hand side only to the correct floor shape before 1990-1 rib design change---ideal for MK1/2 restoration with original 4 flute indentation. This has the carpet stud brackets plus underside slinger bracket and mul...

($90.00) £90.00 exc vat

($108.00) £108.00 inc vat
FLOOR PAN FRONT TO REAR R/H PRE 1990
FS006R

Floor pan front to rear for the right hand side only to the correct floor shape before 1990-1 rib design change---ideal for MK1/2 restoration with original 4 flute indentation. This has the carpet stud brackets plus underside slinger bracket and mult...

($90.00) £90.00 exc vat

($108.00) £108.00 inc vat
FRONT PANEL MINI 1965->1976 (ALSO FITS PRE1965)
14A8308

Genuine front panel fits all pre rubber mounted subframe cars .

The early pre 1964 Mk1 had different shape lower valance without cut aways under the bumper apron but this genuine panel will fit all.

There is a good aftermaket panel...

($199.00) £199.00 exc vat

($238.80) £238.80 inc vat
WING INNER AND A PANEL R/H MK3 1970 ON
ABD36004

Inner front R/H wing with the A panel and door stiffener check strap panel attached for ease of fitment and alignment. Always check the bonnet prop bracket location as they changed.

($250.00) £250.00 exc vat

($300.00) £300.00 inc vat
FRONT PANEL LATE RUBBER MOUNTED 1976-1997
MS4L

This late front panel will fit any Mini, with rubber mounted subframes, manufactured after 1976. It is probably easier to replace the entire panel than to repair a damaged one, especially if it's been hit more than once. Early Minis can use [link]MS4...

($82.50) £82.50 exc vat

($99.00) £99.00 inc vat
FLOOR PAN FRONT R/H 1991 on
MSL25R

Aftermarket version of the R/H floorpan for 1992 on cars.

This floor was made stronger to prevent vibration and rust and will fit any Rod change gear shift mini started on the first injection cars

($34.50) £34.50 exc vat

($41.40) £41.40 inc vat
INNER WING R/H 1970-2000 INTERNAL HINGE
ABD36006

Right hand inner wing section only for MK3 cars with 3 air vent holes. One with 4 bolt holes,one with 4 castellated bolt holes (nuts welded in place) and one large trunk hose hole at front. If you want the same panel with A panel combined for better ...

($200.00) £200.00 exc vat

($240.00) £240.00 inc vat
MINI CLUBMAN FRONT PANEL - '76 ON RUBBER MOUNTED
AAM1022

lower section known as front panel for the clubman range only.his is the rubber monted subframe type as fitted from 1976 on-the earlier type which bolted direct to the subframe is CZH563

($145.00) £145.00 exc vat

($174.00) £174.00 inc vat
WINDSCREEN CORNER PANEL R/H
MS6R

A non genuine panel made for repairing the corner of the windscreen panel which is prone to rust from water splashing up from underneath the front wheel arch.

Experience has shown its easier to fit the genuine panel HMP441001 al...

($16.88) £16.88 exc vat

($20.26) £20.26 inc vat
WINDSCREEN SURROUND LOWER PANEL REPAIR
HMP441001

Genuine panel that has the holes for wipers and jets with only a few inches of pillar which is basically the area that rots. Also referred to as the windscreen scuttle lower panel. Fitting the genuine type ensures you should get a better windscreen a...

($160.00) £160.00 exc vat

($192.00) £192.00 inc vat
FRONT PANEL MINI 1990->1997 TAKES AFU3389(2 spotla...
ASJ36002

For 1990on and single point injection cars with 2 spotlamp holes and for AFU3389 sidelamps held on by 2 screws. See ASJ360070 for twin point cars with 4 spots and different bonnet locking position.

($199.00) £199.00 exc vat

($238.80) £238.80 inc vat