($239.25) £239.25 exc vat
($287.10) £287.10 inc vat
Special order
version of Cobra seats and has dep sides and a low back to ensure comfort and support without the restrictions of a larger seat. red vinyl and no piping
($239.25) £239.25 exc vat
($287.10) £287.10 inc vat
Special orderRecommended usage 2 x SEAT01REDV to fit one mini.
Universal to fit many vehicles and definately the mini for all Cobra seats but beware if your original seats lock down to the floor as a safety requirement. These do not lock down. The MOT testers in the UK could fail you if yours were originally th...
If your vehicle had a seat that locked to the floor it is an MOT requirement that you fit that type of fitting seat back in for safety requirements. This seat frame will allow you to fit the Cobra range of seats to your mini.
See [link]SEAT1...
If your vehicle had a seat that locked to the floor it is an MOT requirement that you fit that type of fitting seat back in for safety requirements. This seat frame will allow you to fit the Cobra range of seats to your mini.
See [link]SEAT1...
Auto retractable seat belt kit. Sold per seat. The manufacturer states that these belts are direct replacements for the pre tensioner types fitted in Europe.
It will arrest the wearer within the same tolerances without a need for a...
In 1993 the seat frames were changed and although the base frame looks very similar to earleir models, there is a difference in the shape. At this time the seat diaphragm was changed to a special rubber/woven design known as the "Suisiara" model. The...
The full rubber style seat diaphragm for early cars 1962-70. This one-piece rubber seating includes mounting clips. Many fit this to later cars as well although a wire strap type CZH3508MS is also available. The clips are also available ...
Full carpet boot liner kit, completely lines the inside of the boot area.
Not suitable for MPI minis.
Metal chromed old type classic handle revived for use on MG variants and then a fashion item on minis. On later cars CMZ312 screw might be required which has a smaller diameter head and longer thread. Length 90mm.
This red carpet is the correct moulded shape with insualation material attached where appropiate for that smart fit over the gearbox tunnels etc.For vehicles pre 1972 with remote or magic wand type gear levers you will therefore have to cut this hole...
2 outer rings and 2 inner knobs which have to be stuck on.
Lower moulding clip for wind up window mouldings..4 PER SIDE required but sold singly-Fits CZH1666/7 and PAM1014/5
Also used for 24A1169 glove box moulding MK1/2.
Mk1/2 style pattern door and rear quarter red vinyl trim kit
These are the 4 major parts that can give your car a fresh look- only fits wind up widow type doors as fitted to MK3 range mid 1973 , without ash tray facility in rear glove box
Dash liner black painted cardboard without airvents and oval hole for deluxe speedo cluster.Not for single speedo only cluster.For Vinyl leathercloth type see ALE2927
handbrake handle in Burr walnut to compliment the wooden dashes.
The inside is rough finished and depending on year of car tape will have to be
used on the lever to make this a snug fit.
See also MSA0193 door ...
Lovely Burr walnut dash for left hand drive cars with 3 clocks in front of driver.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.