(10,69 €) £10.69 exc vat
(12,83 €) £12.83 inc vat
Out of stock
(10,69 €) £10.69 exc vat
(12,83 €) £12.83 inc vat
Out of stock
Replacement headlight switch as fitted to all models from 1976 until 1997.
Courtesy switch for MPI minis from 1996 when the wiring was changed from bullet type to spade connection. This is the switch that fitted into the A post to turn the interior light on and off, the earlier switch is no longer available so if you have a...
On /Off safety swith guard and press starter switch,a red and green safety light plus one switch, no wiring included. Plate size 65mm x 135mm.
Rear fog lamp switch with the orange illumination segment for all vehicles fitted with production fog lamps as standard. 3.1cm tall from 1976 on.
Metal plate switch carrier for 5 square type switches.
IGNITION BARREL TO FIT 13H337 SWITCH. MK1/2/EARLY MK3. ONE BARREL,TWO KEYS
circuit breaker for safety as required in motorsport
The switch has to be accessible from inside and outside the car.The external trigger should be located on the windscren scuttle panel -preferably the drivers side . It should be clearly ma...
Brake light switch for pre 1976 minis with single line brake systems. Fits into banjo bolt (7H7995) located at O/S front brake hose. This switch has a tapered thread. Made by a UK company who suplied parts to Unipart.
For minis ...
Used on Rod change gearboxes and fits on the side of the gearlever alloy housing, the locknut is to prevent the switch being screwed in to far. Use 22A1613 locknut.
This switch fits under the brake pedal on the floor. See also BMK1903A locknut for this item.
Mini Spares genuine product-plastic 2 piece casing for the steering wheel cowl was introduced in 1976 which was for the introduction of twin indicator stalks and a different steering lock. Twin point injection cars have different cowling and switches...
These used to be supplied with a little bracket but it was discontinued by the factory so it now just hangs loose under the dash. But Minispares have re-introduced it as 5L433
A low oil pressure warning light switch is available to help protect the engine. The standard one comes on at 7lb-much too late to avoid damage. This one comes on at 20lb and is adjustable up to 120lb. Please note this is now a twin terminal switch, ...
Single speed heater switch for MK3 cars from1970 to 1996 only, as Rover changed to a twin speed heater fan with a new switch YUF101410.
This is the only part available for the heater control panel now..
Quantity requir...
Also known as brake failure switch, MK4 From 1976.
Rectangular switch for the rear heated screen with pin connectors plus a spade type. 3.1cm tall, from 1976 on.
HAZARD WARNING SWITCH, PIN TYPE CONNECTORS. MK4 FROM 1976. 3.1cm tall.
This turn signal indicator switch also includes a black button on end for the horn push and a for and aft movement for the activation of high beams. The switch is used on most MK3 Minis and can be distinguished by the use of a plug for interconnectio...
Complete assembly includes 2 shear bolts, lock, ignition switch & barrel assembly and even a spare key. Wiring loom has a four-pin plug. Fitted from MK4 mini (1976 to 1996) up to the introduction of MPI which had air bags fitted and different steerin...
Fitted on the left hand side on 1976-1989 LHD cars and on UK cars from 1984-89.
Fitted from about 1989 until 1996 twin point injection cars this switch was also fitted to early metro type minis and is for horn, headlamp flash and indicators.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.