(96,53 €) £96.53 exc vat
(115,84 €) £115.84 inc vat
In stock
(96,53 €) £96.53 exc vat
(115,84 €) £115.84 inc vat
In stockRecommended usage 2 x XBC105230 to fit one mini.
Pop rivet for fixing the headlamp bowl to the wing. Great for MS14 metal bowl but be careful if using on plastic bowls
Gasket/seal for all 1997 on mpi headlamp bowls (self levelling type).
A single plastic headlamp bowl only, to accept the levelling motor and rim for all twin point (1997 onwards) Minis plus some export SPI models.
The best chrome type available with screw and washer.
A headlight trim ring is only the starting point of a good looking car, but you have to start somewhere. Sold singly 2 required per car. These are the original type chrome over solid bras...
TWin point and overseas cars were fitted with headlamps that self-level for when carrying loads. This is the motor in the headlights.
Single replacement light unit for the Left Hand drive kit S4699B with right hand dip.
lamp part only, does not include the rubber cover, bulb or side light part
If your rusted old headlight bucket is getting to you, don't waste time trying to salvage it when new metal reproduction metal buckets are AVAILABLE.
With a headlamp rim fixing bracket 37H7421 attached
Whether you are ...
The headlamp bucket is isolated from the body with these rubber seals/gaskets.
Headlamp sundries kit.
Includes two adjuster screws, plastic nutserts, pullback spring. Two kits are required per car.
A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...
As fitted from Cooper SE on,it is also fitted to the MPI injection cars with self levelling units. This light unit has a plastic backing and not metal as per our S4700 type.This part is not in a complete lamp but just the glass unit.For ...
L/H/D Headlight unit to accept separate main beam bulb and auxiliary bulb. Uses GLB410 bulb. Sold singly 2 required per car.
This plastic bowl kit includes the inner rim to hold your light unit and will obviously not rust like the old originals. You will need a headlamp outer rim so why not fit our own developed stainless steel variety which is cheaper than even chrome bud...
These stainless steel peaks fit under the headlamp rim to give that old 60s style again.
Single replacement unit for the right hand drive kit S4698B with left hand dip
lamp part only, does not include the rubber cover, bulb or side light part
Fitted to twin point injection cars and a few single point (mostly export)with self levelling function complete less headlamp rim--See 500929ms in stainless steel for rim or 17H5143 for chrome over brass. Comes complete with foam seal. I...
This is the plug that fits on the back of the front indicator lamps (XBD100670) on mpi models.
Stainless steel screw kit for all mk2/3 lens to lamp body. Comes as a car set with six screws and six fibre washers.
The half bowl for holding original sealed beams into the headlamp bowl om minis and many other headlamps of the 60s and 70s. Sold singly 2 required per car.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.