(1,76 €) £1.76 exc vat
(2,11 €) £2.11 inc vat
(1,76 €) £1.76 exc vat
(2,11 €) £2.11 inc vat
Recommended usage 2 x YQG10008EVA to fit one mini.
30 amp maximum fuse for the engine fusebox and management link under the bonnet.
blade or double spade type fuse
Used on the following circuits: Alarm and horn.
Used on the following circuits: Heater blower motor, driving light relay, sunroof motor, wipers/washers, radiator cooling fan, indicators, stop-lights, reversing lights, heated rear window and front foglight relay.
Used on the following circuits: Headlight main and dipped beam, sidelights, alarm and instruments, rear foglight, headlight levelling, ignition auxiliaries, radio, airbag ECU, brake test switch warning light, indicators, clock, hazard warning lights,...
This is the latest model fuse box as used on all Minis after 1976 and all MG Midget/Sprites with 1275cc. Simple and easy to replace or upgrade from the earlier version. This box has the added advantage of having 4 fuses in place of the earlier vers...
circuit breaker for safety as required in motorsport
The switch has to be accessible from inside and outside the car.The external trigger should be located on the windscren scuttle panel -preferably the drivers side . It should be clearly ma...
Replacement fuse. 35 amp was standard for the light circuit and the 'all other' circuit, too, on early cars with the two circuit fuse box.
If you don't remember where your spares are, or you've used them up, you may want to replenish you...
Both personal safety and many sanctioning organizations require the use of switch for easy and complete cutoff of power from your battery. Easy to install and even provides a fused ancillary connection.
The most common use of this "great id...
Genuine Bosch lambda sensor, fitted to both the twin and single point injection cars and fitted in the same exhaust manifold shared by both cars. Be warned the cheaper non branded sensors cause lots of issues hence we only sell the Bosch version.
Pop rivet for fixing the headlamp bowl to the wing. Great for MS14 metal bowl but be careful if using on plastic bowls
Bolts on the side of the injection body housing to control engine idle speed and air flow from cold start up. The blue socket loom cap fits this unit. This is part of MLZ100090. After fitting the cars ignition needs to be turned on and o...
Set of 4 ignition leads from the original supplier to Unipart, suitable for all twin point minis 1997 onwards. For use with M4 type coil.
Gasket/seal for all 1997 on mpi headlamp bowls (self levelling type).
original Lucas type RESIN BASED CONDENSER made for the 45/59D type distributor if you want a quality item rather than the cheaper inferior parts available. Filled with 3m of winding inside as per original Lucas but every copy analysed to date has ...
RESIN BASED CONDENSER as per the original Lucas type made for the 23/25D type distributor as fitted to original Cooper S or Racers who want a trusty part or where originality is required,with soldered wire connections and correctly made foot to sit ...
Screw for holding PRC1230A to the number plate light body, 1970 onwards.