£232.50 exc vat
£279.00 inc vat
In stock
£232.50 exc vat
£279.00 inc vat
In stockRecommended usage 1 x 14A6896 to fit one mini.
Rear subframe mounting stiffener L/H repair bracket with holes for subframe mounting and attaches to wheel arch Fits on ALA8623
Commercial Mini floor extension
It is an essential part for the correct restoration of all the longer wheelbase mini derivatives. From the original tooling.
floor pan front to rear for the left hand side only to the correct floor shape before 1990-1 rib design change---ideal for MK1/2 restoration with original 4 flute indentation. This has the carpet stud brackets plus underside slinger bracket and mul...
Floor pan front to rear for the right hand side only to the correct floor shape before 1990-1 rib design change---ideal for MK1/2 restoration with original 4 flute indentation. This has the carpet stud brackets plus underside slinger bracket and mult...
Metal backing plate rear number plate for vans/estates, has location holes for wires of 2 rear number plate lamps at either end - will only take original size number plates as it is only 4.25" high but about 25.25" long to accept the lamps either end...
R/H rear lower genuine corner section of the rear valance on vans.estates.travellers and pick ups
The rear centre valance section for all vans, pick ups and estates. The corner
pieces of this valance are available separately as 14A6908/9
This panel closes off the front of the R/H wheel arch and the heel board.
L/H rear lower corner section of the rear valance on vans.estates.travellers and pick ups
Genuine valance with fog light holes. If you require a MK1/2 genuine rear valance without foglamp holes order 14A6940.
This rear valance has holes drilled in it for fog lamp wire and fittings from 1983 on. The holes have UNF ca...
Good quality pressing rear upper side panel,used for converting clubman estates to van sides or repairing van upper section back to original when windows have been fitted. This is RH side.
A post inner closing panel/siffener plate R/H external hinge cars.
Not always stocked owing to lack of demand but available to order.
Reproduction version os ASJ360070. For the twin point only as it changed shape to accommodate the front mounted radiator and different bonnet fittings.
For vehicles with external hinges and sliding type windows this is a full inner front wing with the wheel arch panel. The panel is what that the outer A panels for the hinges attach to.This is the left hand pane wing with radiator vent slats but not ...
For vehicles with external hinges and sliding type windows this is a full inner front wing with the wheel arch panel. The panel is what that the outer A panels for the hinges attach to. This is the right hand panel made by Heritage but not 100% perfe...
NON genuine 8"wide outer sill for the van/pick up and estate range with MK3 square pressings. No genuine wide panel is available but see 14A9026/7 for 4" wide panel which actually covers only 2.5" of actual lower floor pan whereas the non genuine pan...
Aftermarket wings do the job at a fraction of the cost of originals. This right front wing for the Mini will fit all MKI, II, III, IV. A slight difference exists between the early and the later models as to headlamp mounting holes. These reproduction...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.