When a boot board is fitted the following brackets are required:

14A9780 x 2 U shaped for the rear to hold the board.

14A9781 x 2 side bracket with plug for board to sit on except elf/hornet.

[link...

The special pointed shape buffer locates against the boot board of Cooper S and variants where a factory type boot board is fitted.

This kit contains all the brackets and mounts required for fitting Minis with 10/12" wheels or with 145 profile tyres.

The boot board bracket 14A9783 is not included

For 10" wheels with 145 tyres and 5.5 gallon tank se...

bracket for boot board R/H on 7.7 gallon tank and on both sides for 5.5 gallon tank when 165 tyres fitted

Full carpet boot liner kit, completely lines the inside of the boot area.



Not suitable for MPI minis.

This kit contains all the floor brackets and mounts required for fitting Minis with 7.5 gallon tank 10/12" wheels or with 165 profile tyres.

The boot board bracket 14A9783 is not included

For 10" wheels with 145 tyres ...

This kit contains all the brackets and mounts required for fitting Minis with 10/12" wheels or with 145 profile tyres.

The boot board bracket 14A9783 is not included

For 10" wheels with 145 tyres and 5.5 gallon tank se...

These gaskets should be changed when replacing the hinges, this one goes between the bootlid hinge on the body, see 24A2175 also for upper on bootlid.

Bootlid seal for Mini <91. Held in place on the boot lid using 26 clips(part# 14A6585).When fitting, the lip part of the seal open end for clips should face the inner boot catch- (the open end of the seal facing inwards to the bootlid al...

Seal for door handles MK1/2 and all sliding window exterior hinge cars.

also used on 14A7195 mk1 boot handlle used on mk1/mk2 and van/estate



is oval shaped



for boot / rear door use the hole at the rear ...

These are the little 'whisker clips' that hold the 14A9907 bezel on the front of the oval 3-instrument gauge pod 24A2702. The 'ears' slot into the back of the bezel and the tails that stick out go thru one of 14 holes in the...

This polished aluminium corner plate fits over the leading edge of the MKI/II door pocket to add protection and class. Only the Nearside plate is supplied.

The MKI & MKII number plate panels 14A6468 are hinged at the top to swing out clear of the bumper when you open the boot lid. They were unavailable for years but now they're back. These & 14A6466 are the hinges.