WIPER BUSH KIT MK3 INNER AND OUTER. USE 37H7201M...
37H7201

£10.50 exc vat

£12.60 inc vat

Out of stockOut of stock
Can be used for MK1/2 minis but you will need to cut to length

£10.50 exc vat

£12.60 inc vat

Out of stockOut of stock

Alternative products

Black bushes for wiper wheelboxes. Sold as a wiper wheel box set(one above the windscreen scuttle cowl and one under the cowl), takes two sets per car.

To fit early Mk1/2 cars cut down the part that fits under the panel work part(this part h...

People also bought products

Almost any screw will hold the chrome headlamp bezel on, but only one is correct! These screws are stainless steel and will never corrode plus they have the little rubber washer on the backside so that the screw will not fall out when trying to fit ...

This is the spiral wound cable that is in the wiper rack tubes. It needs to be cut to length.

Total length uncut is 150cm.

WIPER SWITCH,FITS MK1/2/EARLY MK3.TOGGLE TYPE.2 POSITION.

HAZARD WARNING SWITCH, PIN TYPE CONNECTORS. MK4 FROM 1976. 3.1cm tall.

In pvc tape covering as original for dynamo type Cooper S MK2 cars, 3 wires to wiper motor. Complete with rear loom.

Windscreen wiper wheel box fitted on Mk3 Minis from 1971 on plus all Mini Clubman. 32 teeth.Sold singly 2 required per car

This part often fails and if the conection points look dodgy replace the socket 520161 which also has a small loom.

Lots of things have been written about performance plug ignition wires but regardless of what you believe we all know that good wires are a must. This special competiton wires set from the Lucas factory has 8mm silicon wire and the highest performanc...