£209.79 exc vat
£251.75 inc vat
£209.79 exc vat
£251.75 inc vat
Recommended usage 1 x 5L832 to fit one mini.
This is the wiring short conversion loom that fits to the old central speedo and is used by people modifying from 2 or 3 clock dashes to single clock or just repairing damaged looms. With the correct bulb holders and spade fittings. Now uses 5x [link...
PVC covered rear loom only for Mk2 with heated rear screen.
Can be fitted to MK3 front loom ( HAM2174 ).
Braided cloth wiring loom for Cooper S MK1 with alternator. See 5L518 for braided with dynamo.
Complete with rear loom.
1000cc Mini and Cooper (not "S"), 4 wires to wiper motor.
Dynamo
Complete with rear loom.
Wiper Swithch MK1/2/EARLY MK3 blade type switch for using to convert to 2 speed wipers when current 2 speed wiper motor is used.
Single bullet connector used to join the front loom to the rear loom near the wiper motor.
Double bullet connector used to join the front loom to the rear loom enar the wiper motor.
Lightweight alloy Dynamo/Alternator pulley 75mm wide 2.95" and where belt sits 48.895mm (1.925")wide. Fits all Dynamos and 15mm Diameter shaft 16ACR Alternators.
Owing to the cost many use 12A1772 which is 79mm 3.1" wide - [lin...
A single plastic headlamp bowl only, to accept the levelling motor and rim for all twin point (1997 onwards) Minis plus some export SPI models.
Fits early dynamo pulleys with a spacer built in back to fit the dish of this fan - this fan has a keyway slot.
The dynamo is the heart of the charging system.
Non-tach drive type. These DO NOT come with fan or pulley, reuse your old ones or order replacements. See dynamos with alternator internals for extra power GXE1006 negative earth. ...
Genuine L/H lamp.Beware of cheaper inferior lamps for sale.
Fitted from 1976 on as standard equipment this was the Lucas style lamp with the built in reverse lamp.Supplied with gaskets. Many people now change the upper lens to the more fash...
Almost any screw will hold the chrome headlamp bezel on, but only one is correct! These screws are stainless steel and will never corrode plus they have the little rubber washer on the backside so that the screw will not fall out when trying to fit ...
Can be used for MK1/2 minis but you will need to cut to length
IGNITION BARREL TO FIT 13H337 SWITCH. MK1/2/EARLY MK3. ONE BARREL,TWO KEYS
Fuse Box-Pre 1976
Early style twin fuse box as used on many cars and models. If your box is corroded, as most are, then the "Price of Darkness" is bound to strike you.
This is the 'later' early model with blade connectors and comes...
This is the oblong metal box attached to the rear of your round centre speed heads to stabilize voltage to the fuel gauge. For Centre clock Speedo only!
made for negative earth only--BR1310
Used on Rod change gearboxes and fits on the side of the gearlever alloy housing, the locknut is to prevent the switch being screwed in to far. Use 22A1613 locknut.
The headlamp bucket is isolated from the body with these rubber seals/gaskets.