DYNAMO FAN
17D11

£13.00 exc vat

£15.60 inc vat

In stockIn stock
Fits early dynamo pulleys with a spacer built in back to fit the dish of this fan - this fan has a keyway slot.

£13.00 exc vat

£15.60 inc vat

In stockIn stock

Recommended usage 1 x 17D11 to fit one mini.
Alternator, Dynamo & Fittings - Qty 1

People also bought products

Interior lamp with a black on/off switch and pointed torpedo ends.

Also fitted many of the 1959on range of Austin A55/60 Cambridge, MG Magnette etc.

Also there was an alternative lamp with black switch and square ends 13H192 which w...

Lightweight billet aluminium distributor hole blanking plug for pre A+ engines

Lightweight billet aluminium distributor hole blanking plug for A+ engines.

This is an ultra reliable universal hazard light module kit for any Mini that did not have hazard lights as standard (pre 76 cars).



A discreet but important safety upgrade for all classic vehicles.



Should you ne...

Lots of things have been written about performance plug ignition wires but regardless of what you believe we all know that good wires are a must. This special competiton wires set from the Lucas factory has 8mm wire and the highest performance, no br...

best plug for 12g295 head as fitted to 998 cooper--for tuned head use B7ES.

this is good for any head where a lot has been machined off-flat top pistons.

Negative earth only-45D electronic distributor with vac for 1275GT and any pre A Plus 1300cc engine including Sprite and Midget in line engines-

For best performance and tune we advise our electronic Evolution version C-27H7698<...

original Lucas type RESIN BASED CONDENSER made for the 45/59D type distributor if you want a quality item rather than the cheaper inferior parts available. Filled with 3m of winding inside as per original Lucas but every copy analysed to date has ...

RESIN BASED CONDENSER as per the original Lucas type made for the 23/25D type distributor as fitted to original Cooper S or Racers who want a trusty part or where originality is required,with soldered wire connections and correctly made foot to sit ...

NEGATIVE EARTH ONLY..Reproduction CONTACTLESS Distributor suitable for modern day fuels for 850 and 998cc pre 1974 with upgraded rotor arm "Negative earth only". A worn out distributor can cost you both performance and economy. Precise spark timing ...

Stainless steel screw kit for all mk2/3 lens to lamp body. Comes as a car set with six screws and six fibre washers.

This is a dummy control box (GEU6603) for use with the Dynalite alternators, enabling you to keep your engine bay/wiring looking original even when you are using an alternator. All wire can be swapped like for like from your old regulator box except ...

Best on the market, sports coil-Not Lucas. A standard coil can only do so much, and when compression is raised (as in most high performance engines) or improper fuel mixtures occur something better is needed. This sports gold coil with proven origina...

Negative earth alternator is designed to replace the dynamo on early cars whilst retaining the looks of an original dynamo. See GXE1007 for positive earth. Upgrades power by up to 80% with a 40% reduction in weight. Outputs up to 40 amps...

Single bullet connector used to join the front loom to the rear loom near the wiper motor.

Double bullet connector used to join the front loom to the rear loom enar the wiper motor.

Lightweight alloy Dynamo/Alternator pulley 75mm wide 2.95" and where belt sits 48.895mm (1.925")wide. Fits all Dynamos and 15mm Diameter shaft 16ACR Alternators.

Owing to the cost many use 12A1772 which is 79mm 3.1" wide - [lin...

Sidelight bulb holder for XBC103410 and XBC104430 headlights and uses GLB233 bulb-this also fits Cibie unit 37H7589A

Interior lamp (dome lamp) lens. Fitted from 1959 to 1974 (mk 1 2 3).

Fits our 14A9148 and 13H4398 lamps