DUMMY CONTROL BOX FOR USE WITH GXE1006/7
GXE1008

£107.25 exc vat

£128.70 inc vat

In stockIn stock
This is a dummy control box (GEU6603) for use with the Dynalite alternators, enabling you to keep your engine bay/wiring looking original even when you are using an alternator. All wire can be swapped like for like from your old regulator box except ...

£107.25 exc vat

£128.70 inc vat

In stockIn stock

Recommended usage 1 x GXE1008 to fit one mini.
Battery Fixings, Control/Fuse Boxes & Flashers Un - Qty 1

Recommended products

Negative earth alternator is designed to replace the dynamo on early cars whilst retaining the looks of an original dynamo. See GXE1007 for positive earth. Upgrades power by up to 80% with a 40% reduction in weight. Outputs up to 40 amps...

Positive earth only. This alternator is designed to replace the dynamo on early cars whilst retaining the looks of an original dynamo. Upgrades power by up to 80% with a 40% reduction in weight. Outputs up to 40 amps.A dummy control box also avaiable...

People also bought products

LED side repeater lamp for all 1986 on cars. No resisitor required

Brand new modern electronic version of the classic centre speedo, housed in a billet case with OLED display this unit fits as per original speedos. Features include:



*Trip and total miles

*Remote trip reset

*Driv...

Lightweight higher power version of GXE1004 (1.6KW as apposed to 1KW), ideal for race/tuned cars with high compression and cars that need more room for oil coolers etc. See GXE1005RACE for pre engaged.

Negative earth only-45D electronic distributor with vac for 1275GT and any pre A Plus 1300cc engine including Sprite and Midget in line engines-

For best performance and tune we advise our electronic Evolution version C-27H7698<...

RESIN BASED CONDENSER as per the original Lucas type made for the 23/25D type distributor as fitted to original Cooper S or Racers who want a trusty part or where originality is required,with soldered wire connections and correctly made foot to sit ...

Screw for holding PRC1230A to the number plate light body, 1970 onwards.

Plastic holder for the later flasher unit GFU2218. Needs to be mounted to the bulkhead prior to fitting the flasher unit to the holder

Best on the market, sports coil-Not Lucas. A standard coil can only do so much, and when compression is raised (as in most high performance engines) or improper fuel mixtures occur something better is needed. This sports gold coil with proven origina...

Positive earth only. This alternator is designed to replace the dynamo on early cars whilst retaining the looks of an original dynamo. Upgrades power by up to 80% with a 40% reduction in weight. Outputs up to 40 amps.A dummy control box also avaiable...

Negative earth alternator is designed to replace the dynamo on early cars whilst retaining the looks of an original dynamo. See GXE1007 for positive earth. Upgrades power by up to 80% with a 40% reduction in weight. Outputs up to 40 amps...

Single bullet connector used to join the front loom to the rear loom near the wiper motor.

Double bullet connector used to join the front loom to the rear loom enar the wiper motor.

Lightweight alloy Dynamo/Alternator pulley 75mm wide 2.95" and where belt sits 48.895mm (1.925")wide. Fits all Dynamos and 15mm Diameter shaft 16ACR Alternators.

Owing to the cost many use 12A1772 which is 79mm 3.1" wide - [lin...

These are the screws needed to fix the condensor, points, base plate and vacuum to 45D and 59D distributors. For 23/25D type see 17H5106

These are the screws needed to fix the condenser, points and base plate to 23/25D distributors. See 57H5135 for 45D type distributors.

1.0 KW steel gear reduced unit, that draws less current from the battery when starting. Huge increase in comparison to the original units, and are a direct replacement part for the original pre-engaged starter motor.





Not ...

1.0 KW steel gear reduced unit, that draws less current from the battery when starting. Huge increase in comparison to the original units, and are a direct REPLACEMENT FOR ORIGINAL 9 TOOTH INERTIA STARTER MOTOR.ONLY FOR 107 TOOTH RING GEARS. WILL...

Courtesy switch for MPI minis from 1996 when the wiring was changed from bullet type to spade connection. This is the switch that fitted into the A post to turn the interior light on and off, the earlier switch is no longer available so if you have a...