£273.54 exc vat
£328.25 inc vat
In stock
Complete with rear loom.
£273.54 exc vat
£328.25 inc vat
In stockRecommended usage 1 x 5L672 to fit one mini.
Dip switch lead for right hand drives cars, these are not included with new looms.
Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.
Dip switch lead for left hand drive cars, these are not included with new looms.
Dip switch lead for right hand drives cars, these are not included with new looms.
Main wiring loom with dim dip. Fits all 1275 cars with HIF38 carb from 1991-1994. No alarm.
Main and dash loom only.
We sell about 20 of these per year and many are used on similar models to those indicated-Main and dash loom only--No side wing indicators-indicator stalk on right-alternator-rear lamps with reverse lights-steering lock-inertia starter-centre speedo ...
You should always use this kit for fitting any auxiliary spot or fog lamps.
Kit contains wiring and safety relay-cheaper than a burnt out engine compartment.
Please note, SPI and MPI cars have this facility built as standard safety ...
All Minis require an earth strap from the engine to the body and from 1959-1996
they fitted from the gearbox to the subframe. When they introduced the twin point in 1996 it was moved to the upper engine stabiliser arm. About 13"LONG.
When replacing the 520160A parking switch the inner contact areas on the wiring loom are also worn or damaged so we produced this socket and small length of loom.
Universal post type battery earth strap with clamp type fitting and correct length for most alternatives of batteries fitted.
The battery cover made of a special cardboard as fitted to all minis to protect
the battery terminals from metal objects. See also the 14A7666 retaining strap.
This is the wiring short conversion loom that fits to the old central speedo and is used by people modifying from 2 or 3 clock dashes to single clock or just repairing damaged looms. With the correct bulb holders and spade fittings. Now uses 5x [link...
A plastic lamp spade connection with sidelight bulb aperture for use on sealed beam units only. Uses a GLB501 capless bulb. The mini clubman used sealed beams but had independant side lamps and therefore had an equivalent unit less the s...
The only battery cable to run the full length of the Mini, this has a positive type terminal that clamps arond the post rather than the helmet or cap type on much earlier cars. Some cars had slightly shorter cables than this but measure your old cabl...
Complete braided wiring loom for Cooper S MK1 with dynamo and oil filter light switch--as very few of these warning lights still work this loom is also supplied for cars without oil filter waring light and ignore extra wires.
For alternator...
Basically just the rear lamps and number plate lamp wiring loom for mini van.
In pvc tape covering as original for dynamo type Cooper S MK2 cars, 3 wires to wiper motor. Complete with rear loom.
Braided BLACK cotton covering with yellow flashes,this complete loom fits MK2 Cooper S with alternator and 3 wires to wiper - pre wiper plug type.
Complete with rear loom.
For MK1 mini deluxe or Cooper Mk1 with alternator. Braided version
Complete with rear loom.
Braided rear part loom ONLY for MK1 Minis without a rear heated screen.
Large grommet to fit 1"approx holes in bulkhead for items that need to be able to flex and move such as capillary tubes and oil pipes. 7/32" hole size.
The small hole will expand and is also used as wiring loom through bulkhead and battery c...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.