MANIFOLD Y PIECE FOR STD BORE LCB WITH TEST PIPE T...
C-AHT195

£52.50 exc vat

£63.00 inc vat

In stockIn stock
"Y" Piece for Maniflow LCB C-AEG375 with test pipe sensor take off (not lambda).

£52.50 exc vat

£63.00 inc vat

In stockIn stock

Recommended usage 1 x C-AHT195 to fit one mini.
Inlet and Exhaust manifolds except Injection - Qty 1
Inlet and Exhaust manifolds for Injection Cars - Qty 1

People also bought products

This popular size clamp fits the y piece where it joins the manifold on all our standard long centre branch exhaust manifolds. Sold singly.

If you wish to delete the catalyst (legal restrictions apply, so check to see if you are allowed) this pipe is specially made to replace it.

Link pipe for fitting between the LCB and the catalyst. It has a stainless steel knuckle joint to prolong life and give the flexibility required on the system to overcome damage. See also alternative RC40-016

Y piece replacemen...

The very rear bobbin type mounting rubber on every mini made until the introduction of a rubber hanger strap in 1992. When the RC40 or similar systems are fitted, 2 will be required. This is a stronger poly version.

Blanking plug to blank of the Lambda sensor hole on all SPI/MPI models.

M10 metric flanged bolt 35mm long for catalytic converter. (4 required per unit)

THE M10 METRIC NUT THAT SCREWS ON THE THREAD BOLTS OF THE CATALYLITIC CONVERTER

Catalytic converter to fit all mini models and if you require new studs the part number is FB110351 and the nuts to fit the studs are NV110051.

All are M10 metric thread.

Complete mounting kit for the RC40 exhaust. Includes all new rubber mounts, brackets and clamps.

Metal gasket for the catalyst and is the same both ends for Cooper 1275CC RSP early cars, but only fitted on the front to later cars. If you cannot fit this gasket on the rear your car does not need one.