REAR FLOOR PAN R/H NON GENUINE VAN/PICKUP/ESTATE
MS26RVAN

£40.50 exc vat

£48.60 inc vat

In stockIn stock
with bracket for floor carpet on Estate

£40.50 exc vat

£48.60 inc vat

In stockIn stock

Recommended usage 1 x MS26RVAN to fit one mini.
Van, Estate and Pick up Floor - Qty 1

People also bought products

Non Genuine L/H lamp repair panel for rear corner panel on the Mini Pick-Up.

The top rear capping panel is also available as 14A7558CAP

Non Genuine R/H lamp repair panel for rear corner panel on the Mini Pick-Up.

The top rear capping panel is also available as 14A7557CAP

Body side rear lower w/arch to rear section of bodyside repair L/H. 220mm tall.

Front A panel part of door frame for internal hinge cars Left hand.Non gen

Front A panel part of door frame with door stay hole for internal hinge cars right hand non gen.

Aftermarket version of the rear L/H floorpan for 1992 on cars with cuved shape for tunnel.

Appears to be a part section of the genuine whole length floor Right hand side.

This has extra length to go just under x memeber at 37.5"95cm...

Non genuine rear valance closing panel with subframe mount repair



The rear valance of the Mini is a panel that is very often in need of replacing. While rear end damage can be a good reason, the most often cause is rust. The pane...

Non genuine rear valance closing panel with subframe mount repair



The rear valance of the Mini is a panel that is very often in need of replacing. While rear end damage can be a good reason, the most often cause is rust. The pane...

L/H narrow 6 flute outer sill for mk3 saloons to 2000 but most 1970 cars and Cooper S mk3 had 4 flutes--Great quality and fitting aftermarket panel

This Non genuine pattern panel has the holes for windscreen wipers and jets with barely an inch of pillar.

On cars from 1992/3 on check the original windscreen drain channel as the VIN numbers were stamped above the clutch master cylinder-wi...

The rear lower side and rear corner panel for the Mini Van, Pick-up and Estate are all the same. This repair panel is intended to be spliced in to replace a most often rusted spot!

the left hand waist rail that is supplied on a new bodyside from us.

Acts as a stiffener on the inside of the bodyside between the rear seat pan and the B post just under the rear opening side window

Commercial Mini floor extension

It is an essential part for the correct restoration of all the longer wheelbase mini derivatives. From the original tooling.

NON genuine 8"wide outer sill for the van/pick up and estate range with MK3 square pressings. No genuine wide panel is available but see 14A9026/7 for 4" wide panel which actually covers only 2.5" of actual lower floor pan whereas the non genuine pan...

A non genuine panel made for repairing the corner of the windscreen panel which is prone to rust from water splashing up from underneath the front wheel arch.

Experience has shown its easier to fit the genuine panel HMP441001 al...

Non genuine body side skin from door back and below window line for the left hand side

non genuine oversill MK1/2 van floor profile R/H with 4 flute vents

see MS58R for 6 flute type side, wide type