(¥124) £124.13 exc vat
(¥149) £148.96 inc vat
In stock
(¥124) £124.13 exc vat
(¥149) £148.96 inc vat
In stockRecommended usage 1 x CZH651 to fit one mini.
everybodies favourite front bonnet shield type badge fitted to the Italian Job special edition cars bonnet
High quality non genuine door check strap for MK3 cars with wind up window doors (use with retaining pin CLZ412). Beware there are cheap copies on the market that are poor quality and when fitted to our cars did not function correctly!
Clip for Door Handle required when changing barrel set. Heavy duty round spire clip specially made for the job.
In 1993 the moulding between the wheel arches was changed from black plastic to rubber and was still used on twin point rubber arches. This is the Minispares version which is a slightly more rounded profile.
Really a built up half front end for the mini clubman, consists of a lower panel with headlamp panels,slam panel and stiffener between the front and slam panel,
but not inner or outer wings
Boot badge for the Mini clubman in black and silver 6" long by 1" high
Mini Clubman front bumper, a very good copy produced from new tooling in a high quality chrome finish.
Remember-all chrome needs regular washing and cleaning as atmospheric filth contaminates modern day chrome,
For rear bumper see ...
Stainless steel GB badge made with the correct bend and shape to fit the bootlid on minis. They stick on with top quality double sided tape which is already attached, but before fitting you must first remove any wax polish film,or road grime by eithe...
Sponge type seal on L/H A post of all minis with wind up window type doors to protect from water running down into body. A part you must keep your eye on to stop rust.
Sponge type seal on R/H A post of all minis with wind up window type doors to protect from water running down into body. A part you must keep your eye on to stop rust, if the sponge is gettig hard then replace it.
This is a budget way of improving the stability of the front subframe leaving the rear mountings standard for quietness.
It only includes the 4 poly tower spacers and for the front of the front subframe 2 poly spacers and 2 metal washers.
All mini windscreen and backlights have this plastic moulding in the middle 99% of the time. Chrome in colour, this is on a 30metre roll for trade use.
PW5013 is the black equivalent.
Fitted to inner wing 1990 on, plus on a bracket on the rear wheel arch in boot area for all single points onwards. For earlier cars where fitted on the bulk head you may need to put a spacer behind to make removal of bottle easier.
Original ...
This is the boot seal that actually fits on the car body which saved drilling holes in the bootlid. Fitted from about 1988 on.
These gaskets should be changed when replacing the hinges, this one goes between the bootlid hinge on the body, see 24A2175 also for upper on bootlid.
These gaskets should be changed when replacing the hinges-this one goes between the bootlid hinge on the bootlid. See also 24A2176 for gasket on body.
These two simple cables are all that keep the boot lid from crashing down, damaging hinges, bumper and paint. When one fails we recommend replacing both to be sure of the same length. sold singly 2 required per car
37H3043 can be u...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.