(¥26) £25.73 exc vat
(¥31) £30.88 inc vat
Out of stock
not mini clubman
(¥26) £25.73 exc vat
(¥31) £30.88 inc vat
Out of stock
Crossmember at the back of the engine bay where the master cylinders fit, fits MK1/2 models.
correct shape for a mark one unlike the laster version that is modified for carb clearance
Crossmember to inner wing bracket bracket for Mk1/2 L/H
not mini clubman
Rear subframe mounting stiffener L/H repair bracket with holes for subframe mounting and attaches to wheel arch Fits on ALA8623
For vehicles with external hinges and sliding type windows this is a full inner front wing with the wheel arch panel. The panel is what that the outer A panels for the hinges attach to.This is the left hand pane wing with radiator vent slats but not ...
For vehicles with external hinges and sliding type windows this is a full inner front wing with the wheel arch panel. The panel is what that the outer A panels for the hinges attach to. This is the right hand panel made by Heritage but not 100% perfe...
2-3" lower section of body section
from A post to rear wheel arch including the vital door step sill profile that rusts plus the horizontal edge that the chrome trim sits on-for cars with hinge type doors.
You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width with vertical flanges for easy installation, and fairly well represent the original stamping. They have added metal to includ...
2-3" lower section of body section
from A post to rear wheel arch including the vital door step sill profile that rusts plus the horizontal edge that the chrome trim sits on-for cars with hinge tye doors
rear subframe mounting stiffener L/H repair bracket with holes for subframe mounting and attaches to wheel arch Fits on ALA8623
This panel has mounting holes for later models facia crash panel. These holes will require blanking for true originality on earlier models without the facia pad
Closing plate against the bodyside in the base of the l/h rear companion/glove box now has a square pressing hole for later models
the A post repair panel with hole for coureousy light swith about 8" of metal below and above the hole, for external hinge door types
This reinforcement for the bonnet platform panel was fitted to Cooper S models at an angle to enable fitment of oil cooler from 1966 on. Originally these were riveted by 2 pop rivets either end for all MK1 Cooper S. Painted black they were even found...
the A post repair panel with hole for coureousy light swith about 8" of metal below and above the hole. External hinge type cars MK1/2 and vans etc.
Genuine panel that has the holes for wipers and jets with only a few inches of pillar which is basically the area that rots. Also referred to as the windscreen scuttle lower panel. Fitting the genuine type ensures you should get a better windscreen a...
closing plate against the bodyside in the base of the r/h rear companion/glove box now has a square pressing hole for later models
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.