Large steering wheel nut for all pre air bag models, and a shakeproof washer 53K3480 must be fitted for safety reasons.1 5/16" spanner size 1.3125" wide (33mm).

This is the important steering column/pedal box bracket clamp (usually yellow).

Bolt for the bottom of the inner steering column to lock it onto the steering rack spline. This is a Rover special fitting bolt with a 1/2" plain shank to fit the inner steering column groove.

As it is an expensive bolt, for any other purpos...

Large steering wheel nut for all pre air bag models, and a shakeproof washer 53K3480 must be fitted for safety reasons.1 5/16" spanner size 1.3125" wide (33mm).

Plastic upper bush that should be replaced when you have play between the inner and outer steering column. Remember to change the bottom as well whether it be felt or plastic type.

Fits 1985 to 1997 cars but can be used for earlier steering lock type cars by

using later bush and cutting the outer column down to size at the bottom.

If you had an indicator pin on your original you will need to drill and tap to ...

This is a strange shaped nut which locks the bolt which goes through the upper

column bracket which in turn clips to the body bracket. 5/16" unf thread.

All steering wheels pre air bag (twinpoint injection cars 1997 on) should have this shakeproof washer fitted under the large securing nut (ACH6001) and should be replaced every time the wheel is removed.

Do not forget to replace the top plastic bush GSV1095 when replacing this lower felt type bush. From 1985 Rover changed to a plastic bush NAM8563 on the bottom with a different outer steering column shroud.

The sponge dust shield that fits over the splined area of the steering rack as it bolts up against the bulk head. Usually it is sold with the centre part cut but not pushed out, but it pops out easily and is shown on our picture as a reference only. ...

This is the rubber gaiter that fits suspension knuckles GSV1118, GSV1118MS, Plus it also fits many aftermarket and some old genuine track rod ends. Rover and Unipart changed designs and suppliers many times so we cannot advi...