£8.36 exc vat
£10.03 inc vat
In stock
£8.36 exc vat
£10.03 inc vat
In stockRecommended usage 1 x 21A2466 to fit one mini.
Bolt for the bottom of the inner steering column to lock it onto the steering rack spline. This is a Rover special fitting bolt with a 1/2" plain shank to fit the inner steering column groove.
As it is an expensive bolt, for any other purpos...
The first thing I do when I get a new Mini is to add a steering column adjuster. This bracket lowers the wheel 1" to 3" for a sportier driving position.
Always make sure you release the tension on the steering rack by loosening the 4 nuts o...
Large steering wheel nut for all pre air bag models, and a shakeproof washer 53K3480 must be fitted for safety reasons.1 5/16" spanner size 1.3125" wide (33mm).
Plastic upper bush that should be replaced when you have play between the inner and outer steering column. Remember to change the bottom as well whether it be felt or plastic type.
Special 25.4mm size nut to hold the steering wheel .
Earlier cars had a 33.3mm wide nut ACH6001. Same internal thread as earlier type with locking agent on thread for safety. Fitted from about 1990 on except MPI which has spcial...
On all cars with a steering lock there are safety shear bolts on the column which will need replacing if removed. This is the 5/16"unf 2.0125"thread and stud length 2.70"(68mm)- overall length long bolt that holds the steering column bracket to the c...
This is a strange shaped nut which locks the bolt which goes through the upper
column bracket which in turn clips to the body bracket. 5/16" unf thread.
On all cars with a steering lock there are safety shear bolts on the column which will need replacing if removed. These are the 2 (5/16"unf)bolts 7/8"long thread that hold the steering column bracket to the dash rail. 1.5"(37mm) long overall.Sold sin...
All steering wheels pre air bag (twinpoint injection cars 1997 on) should have this shakeproof washer fitted under the large securing nut (ACH6001) and should be replaced every time the wheel is removed.
Small split white plastic bush for lower steering column from 1985-96 pre air bag models. Always change the plastic upper bush GSV1095 as well when you do this job.
The boards that sit on the facia tray of cars built after 1970 as a base for the vinyl cover VGA1995
Earlier cars had a full panel metal tray and do not require these support boards.
Lower internal door hinge for either side.
Fits all wind up window type doors from 1970 on.
upper door hinge l/h for wind up window type door with internal hinge 1970on
this is not a genuine part and is available in a car set kit MSSK017B
See CZH203 for genuine
The safest way to have a bonnet lock is an internal release type, as fitted to all the late Minis FROM 1992/3 on. The kit includes a new catch with bolts, correct length cable and bracket to fit at the end of the parcel shelf. Not suitable for clubma...
Moulded shape type right hand door stay grommet fitted until 1985 when it was replaced by a flat sponge type seal CGE10038/9.
Holds the window regulator to the door on wind up window minis from 1970 on.
Also holds fog lamp bracket to rear valance. 1/4" unf with 1/2" thread on
panhead type screw.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.