SEAT REAR SQUAB FOAM MINI 1967-1980
SF678

(¥41) £40.94 exc vat

(¥49) £49.13 inc vat

Out of stockOut of stock
Under all seat covering is a foam and this is the rear seat foam squab,the part you sit your back against for saloons from 1967-1980.The foam fits over the rear seat frame and is folded over that frame to give soft corners. The vertical

bol...

(¥41) £40.94 exc vat

(¥49) £49.13 inc vat

Out of stockOut of stock

Seats and trim - Mini saloon & Cooper & 'S' MK2 1 - Qty 1
Seats and Trim - Mini 1275GT - 1969-1980 - Qty 1
Seats and trim - Mini MK3 - MK4 1969-1980 - Qty 1

People also bought products

Static 3 point fixing front seatbelt with the female fixing on a stem.

FIA spec anchor plate for eye bolts, used when fitting harnesses. Sold individually, 7/16 UNF 65x65x3mm.

Front seat squab foam.This squab foam can be used for most models from 1980 to 1992/93 seat with single post head rest. C708 is the diaphragm for this.

This squab was used exclusively on minis 1985-1992 before the introduction o...

One pair (saloon car set) of rear quarter door cards in black , 1976 - 1980

Headlining kit including C post trims in cream crackle for 67-69 Minis which have a larger rear screen.

Cream with crackle finish sun visor fitted as standard from December 1965-69 but will fit Mk3 on if required. With mirror for passenger side. For a car set of clips see SV2021

Mk1/2 1965 on cream crackle SV2017C

Mk3 196...

Cream colour crackle finish sun visor as fitted from december 1965 onwards. Will fit later cars if required. Drivers side without mirror.Check out the special clips to hold these visors as they are sold seperately in car sets only as SV2021<...

Light grey plastic 6" mirror fitted by BMC as standard from October 1964-69.

The first light grey plastic 6" mirror with a twin ball stem and black sucker was patented in 1962 but not fitted until October 1964. At the end of 1965 the twin ba...

Eye bolt for harness mounting. sold individually, 7/16 UNF.

couser grain than WAC3024 fitted from 1970 on Coooper S -Clubmans and 1970 on itermittently.later cars had the finer grain pattern WAC3024A but black all look the same in the car. Comes in a pair.

Multi purpose square plastic plug/nut for No8 screw size was used on many door fixings and fuse box to body.



Also suitable for Twin Point indicator fixings.

127cm long and 43cm wide this is enough leather cloth trim that fitted S and deluxe models on the upper and lower facia plus the winscreen A posts. Fitting instructions are included but no glue.

This is a car set of the 8 floor stud, the triangular base and three hook clip

that originally held your carpet set in place.

Parts are available seperate as

2H8445 - CLIP

14G8736- BARB ...

Make it like a Rolls Royce! The Mini will never be as quiet as a Rolls but every bit helps. If you have a carpet kit without this insulation you are missing a great opportunity for increased comfort. The kit includes a tailored floor set,front wheel ...

Mk1 Mini Indicator stalk green lens. Also fitted to other BMC variants such as Morris Minor. See GLB280 for the replacement bulb

Favourite old ashtray for MK1/2 minis with the fluted top for the rear glovebox and facia. Fitted to minis with painted top dash rail from 1959-85.

See 24A1538 also for flat lid version as fitted when top dash rail is vinyl cove...

These special hoses are for all sliding window type doors to drain the water away from the channels. The thin end of the hose slides into the bottom tube to ensure water goes out and cannot leak into the bottom of the door and the top slides over the...